LUXPRO LP600V2 High-Output Small Handheld LED Flashlight User Manual
- June 6, 2024
- LUXPRO
Table of Contents
LUXPRO LP600V2 High-Output Small Handheld LED Flashlight
Features
- Constructed with aircraft-grade aluminum
- LPE optics
- Patented TackGrip molded rubber grip
- High quality wirst lanyard
- Tactical on/off button
- IPX4 waterproof rating
- Batteries included (4 AAA)
ANSI/PLATO FL1 STANDARD
MODES
|
LUMENS
|
RUN TIME
|
BEAM DISTANCE
High| 400 lm| 2h| 275 m
Medium| 155 lm| 6h| 155m
Ultra-Low| 35lm| 22h| 74m
Strobe| 400 lm| —| —
Operation Instructions
On/Off: Press and release the button on the tail cap to turn the
light on and off.
Cycle Modes: Press button on tail cap quickly to cycle through modes (High/Medium/Ultra-Low). If the light remains in a single mode for longer than 3-5 seconds the next press of the button will turn the light off.
Light automatically resets to High mode when turned off.
Hidden Strobe On/Off: Press and hold button for 3 seconds to activate hidden strobe. Flashlight will remain in hidden strobe mode until it is deactivated by pushing and holding the button for 3 seconds again.
Once the battery has drained too low to allow the flashlight to run on high mode, the LP600V2 is programed to turn off. At this point the flashlight can still run on medium and low modes. Continuously running the flashlight in high mode and turning the light on and off will drain the battery of the light more quickly.
Battery Replacement
The LP600V2 uses 4 AAA batteries.
To change the batteries, turn the tail cap counterclockwise to remove it. Tip
the light downward to slide out the battery case which contains the batteries.
Remove the batteries from the case and insert new batteries according to the
(+/-) symbols found on the case. For best results, we recommend using brand
new alkaline batteries that are the same voltage and brand. Re-insert battery
case into flashlight with the metal knob and arrow on the battery case
pointing down. Re-attach the tail cap by pressing down lightly and turning it
clockwise until tight.
If you know it will be a while between uses, we suggest removing the batteries from the flashlight and storing it in a dry, protected place.
Product Warranty
The LP600V2 has a Limited Lifetime Warranty Against Manufacturer’s Defects
from time of purchase.
For warranty claims please contact us by calling
801-553-8886 or sending an email to
info@simpleproducts.com
luxpro.com 14725 S Porter Rockwell Blvd Ste C
866.553.8886 Bluffdale, UT 84065
luxpro.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>