DS18 SLG-UDSD6LD Polaris Slingshot Under Dash Enclosure Owner’s Manual
- June 13, 2024
- DS18
Table of Contents
OWNER’S MANUAL
SLG-UDSD6LD
POLARIS SLINGSHOT UNDER DASH ENCLOSURE
WITH DUAL ZR6.4D SUBWOOFERS INCLUDED
FOR ALL ELEMENTS
INTRODUCTION
If you’re looking to maximize sound in your Polaris Slingshot, you may consider adding this durable Polyethylene Passenger Side Under Dash 6.5″ Subwoofer Enclosure by DS18. This enclosure allows you to mount two 6.5″ subwoofers underneath your dash to give you the bass your stereo system deserves without compromising your storage compartments. This enclosure comes with a black textured finish to match the factory’s look. Very easy to Install using supplied bolts directly into place and do not interfere with your factory glove box.
FEATURES
- 600 Watts RMS Power Handling.
- 1200 Watts MAX Power Handling.
- Two 6.5” ZR6.4D Subwoofers Included.
- 1 Ohm Total Load Impedance.
- Easy to install – All Hardware and Wiring Included.
- OFC tinned 12Ga Wiring for More Power Handling and Durability.
- Fits Slingshot Models from 2015 or later
- Coated Metal Bracket for better Resistance to the Elements.
- Durable (PE) Waterproof Enclosure with UV Protection.
- 0.3ft3 / 8.5L Sealed Type Enclosure.
- Damping Material for Better Subwoofers Performance.
- Black OEM Finish
WHAT’S IN THE BOX
- Subwoofer Enclosure with Two ZR6.4D Subwoofers
- Mounting Bracket
- 2 x M8 x 1” Screws and washers
- 6mm Allen key
INSTALLATION
Open the hood of the Slingshot to get access to the engine bay and look at the glovebox area in the passenger side, you will see a plane area where two pins will align with the bracket provide. (Picture 1)
For the pass-through screws, if you have a 2017-Up all the holes are pre- drilled from factory, for older model you need to open these two holes using a ½” drill bit. (Picture 2)
Remove the Subwoofers from the enclosure and remove the damping material to get access to the mounting location. (Picture 3)
Place the enclosure in the final location under the dash with subwoofer holes facing down. (Picture 4)
Then use the included M8 screws and insert them from the inside of the box, align it with the previously opened holes, using the supplied Allen key, tighten it as far as it will go by hand. (Picture 5)
Do not forget to put back the damping material and install back the Subwoofers, be careful not to over-tighten or the hole may be damaged and not properly secure the subwoofer. (Picture 6)
This kit needs an aftermarket amp pre-installed with the speaker wires in this
location, only after this step can you install the speakers using the
aftermarket amp’s speaker wire.
This concludes the installation of the SLG-UDSD6LD and it is ready to enjoy
your new sound system upgrade!
SPECIFICATIONS
Speaker Size ……………………………………………………………. 2 x 6.5″
Total Impedance ………………………………………………………. 1 Ohms
Total RMS Power Handling ……………………………………….. 600W
Total MAX Power Handling ……………………………………….. 1200W
Sensitivity (1w/1m) …………………………………………………….. 90dB
Frequency Response ………………………………………………….. 38Hz-200Hz
Recommended Lo Pass Crossover ………………………………… 20Hz
SPEAKER SPECIFICATIONS:
Voice Coil Diameter …………………………………………………….. 1.5″ / 38.8mm
Voice Coil Former Material ………………………………………….. Aluminum
Winding Material ………………………………………………………… Copper
Cone Material ……………………………………………………………… Non-Pressed Paper
Dust Cap Material ……………………………………………………….. PPI
Surround Material ……………………………………………………….. Foam
Basket Material ……………………………………………………………. Steel
Magnet Material …………………………………………………………… Ferrite
Magnet Weight …………………………………………………………….. 50 Oz
BOX SPECIFICATIONS:
Internal Volume ……………………………………………………………. 0.3ft3 / 8.5L
Load Configuration ……………………………………………………….. Parallel
Box Type ………………………………………………………………………. Sealed
Box Material …………………………………………………………………. Polyethylene (PE)
Finish Material ………………………………………………………………. Black
-3Db Dropping Point (F3)………………………………………………… 42Hz
MEASUREMENT:
Overall Height ………………………………………………………………… 6″ / 152.4mm
Overall Width ………………………………………………………………….. 14.6″ / 372mm
Overall Depth …………………………………………………………………… 7.2″ / 183mm
MEASUREMENTS :
| 
---|---
WARRANTY
Please visit our website DS18.com for more information on our warranty policy.
We reserve the right to change products and specifications at any time without
notice.
Images may or may not included optional equipment.
WARNING:
Cancer and Reproductive Harm.
www.P65Warning.ca.gov
FOR MORE INFORMATION
PLEASE VISITDS18.COM
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>