VUL-6703-X-BBZ Low Voltage Landscape Lighting Instruction Manual
- June 6, 2024
- VOLT
Table of Contents
- VUL-6703-X-BBZ Low Voltage Landscape Lighting Instruction Manual
- INSTALLATION & MAINTENANCE GUIDE
- INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS Lighted
- Product Dimensions
- Wire Connections
- Help Hotline:
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
VUL-6703-X-BBZ Low Voltage Landscape Lighting Instruction Manual
INSTALLATION & MAINTENANCE GUIDE
AMP® MarinerPro LED Underwater Light (set of 3) AUL-8000-34-B-BZ
Important Safety Instructions: Read Before Installation
This fixture is intended for installation in accordance with local codes and
the
National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situation.
- Use only in ponds and small decorative fountains where persons will immerse no more than their hands and lower arms while the product is energized.
- DO NOT use in water intended for swimming, wading, immersion, or bathing.
- All installer completed cable connections must be located outside of pond or fountain.
- Low voltage circuit must be supplied by a power unit marked as suitable for supplying submersible luminaires.
- Power unit must be supplied by a circuit protected by a ground fault circuit interrupter (GFCI).
- “Maximum depth: 18 in (450 mm)”.
Important Safety Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS Lighted
lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
- Turn off/unplug and allow to cool before replacing lamp.
- Lamp gets HOT quickly! Contact only switch/plug when turning on.
- Do not touch the hot lens, guard or enclosure.
- Keep lamp away from materials that may burn.
- Do not touch lamp at any time. Use a soft cloth. Oil from skin may damage lamp.
- Do not operate the luminaire fitting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
Product Dimensions
Wire Connections
Place fixture body on your desired location. Strip both leads from luminaire
pigtail. Using two wire connectors (sold seperately), connect
the leads from the luminaire to the main supply cable leads. Make this
connection at least 10’ outside of the water.
Help Hotline:
1-813-978-3900 • Mon-Fri 9am-6pm (EST)
Specifications and product details subject to change without notice.
© Copyright 2019, AMP® Lighting, Lutz FL USA 33549 • All rights reserved.
customersupport@amplighting.com • 813.978.3900
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>