TOPDON BTMOBILE PROS Battery Tester User Manual
- June 6, 2024
- TOPDON
Table of Contents
TOPDON BTMOBILE PROS Battery Tester User Manual
ABOUT
Thank you for purchasing TOPDON BTMOBILE PROS Battery Tester.
Designed to work on 12V batteries within the 100-2000 CCA range,
TOPDONBTMOBILE PROS meets a variety of battery specifications including CCA,
JIS, EN, DIN, SAE, IEC, etc., and also an effective detector to pinpoint the
bad cell.
It adopts the most advanced conductivity detection technology to effectively help maximize the performance of your 12V & 24 V vehicles, giving valuable, easy-to-understand information about the vehicle battery health, alternator’s charging, and starter’s cranking conditions.
The built-in Extra Safe protections against short circuit, reverse polarity, and over voltage allow the tester to safely connect to any battery.
SPECIFICATION
Operating Voltage: 8V~16V
Clamp Line Length: 556mm (21.89 inch)
Operating Temperature: -10°C to 45°C (14°F to 113°F)
Storage Temperature: -20°C to 75°C (-4°F to 167°F)
Operating Humidity: -10°C~50°C,10%-60%RH (Non-condensing)
Storage Humidity: -20°C~ 70°C,10%-80%R H (Non-condensing)
Safety Protection: Reverse Polarity Protection
PRODUCT DESCRIPTION
Indicator Display
Green: Successful Battery Connection
Blue: Successful Bluetooth Connection
Red: Error. Over temperature, or over voltage
TEST RESULTS REFERENCE
Battery Measuring Standard & Range
GETTING STARTED
Step1
Connect the RED Alligator Battery Clamp to the (+) positive battery
terminal, and connect the BLACK Alligator Battery Clamp to the (-) negative
battery terminal. Make sure the battery terminals are clean and the clamps are
securely attached to the correct terminals.
Step 2
Establish wireless communication between BTMOBILE PROS with your smart
devices via Bluetooth 4.2. You can register with your valid email address, or
skip the login procedure.
NOTE: We strongly recommend the registration for latest product news and
timely technical assistance.
Step 3
Select the options with guidance to run the battery test, starting test,
charging test, or battery system test, according to your actual needs.
NOTE: Please turn off all electrical equipment prior to the battery
testing operation.
FAQ
Q: Can BTMOBI LE PROS test the battery installed in the vehicle?
A: Yes, it supports in-vehicle and out-of-vehicle testing.
Q: Is the test result accurate?
A: Yes. Our BTMOBI LE PROS features advanced conductance detection giving you
accurate test results in seconds.
Q: What batteries can BTMOBI LE PROS work on?
A: It works on 12V regular flooded, AGM Flat plate, AGM Spiral, GEL and Deep
Cycle batteries, with CCA between 100 to 2000.
Q: Is BTMOBILE PROS designed with any built-in protections?
A: Yes. It offers peace of mind with extra-safe Reverse Polarity and Spark
proof protection, and easy operations even if you’re new to battery testing.
Q:Can BTMOBILE PROS test 12V solar battery?
A: If your solar battery bank is made up of lead-acid cells, then yes.
Q: How do I confirm if my vehicle battery is bad or good?
A: The battery tester will display SOH (State of Health), SOC (State of
Charge), CCA (Cold Cranking Ampere), Voltage, Internal Resistance, and Rating,
with an intuitive test result of “GOOD” or “BAD” for your reference. If the
internal resistance is too large, it indicates a broken battery.
Q: Can this battery tester estimate the remaining capacity of my battery?
A: Yes. The battery tester will display SOC (State of Charge) to express as a
percentage of your battery’s rated capacity, a measure of its condition to
assess the potential energy.
Note that a decent SOC (State of Charge) doesn’t mean the battery is in good
condition. You need to refer to your battery’s actual CCA Value and Internal
Resistance for further analysis.
IMPORTANT SAFETY INSTRUCTION
FCC Warnings:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
RF warning statement: The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable exposure condition
without restriction.
All information in this manual is based on the latest information available at
the time of publication and no warranty can be made for its accuracy or
completeness. TOPDON reserves the right to make changes at any time without
notice. For more information, please go to
www.topdon.com
PACKAGE LIST
http://service.topdon.com/#/download
Website www.topdon.com
Hotline (+1)833-629-4832
Email support@topdon.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>