DANLEY JH-OFW J-Series Outer Fly-Ware Loudspeakers User Manual
- October 27, 2023
- DANLEY
Table of Contents
DANLEY JH-OFW J-Series Outer Fly-Ware Loudspeakers
PARTS
- 16 x M10 – 1.5 x 45 cm
- 16 x washer
- 16 x locking washer
- 4 x OFW bars
Below is an illustration of how the J-Series Outer Fly-Ware attach to your Danley Sound Labs loudspeaker. The purpose of the kit is to attach load rated rigging points to the loudspeaker.
- For safe rigging, the OFW kit must be attached to the loudspeaker.
- Remove the M10 bolts with a 6 mm hex key on both sides of the speaker.
- Align the OFW bar with the mounting holes and secure tightly with a bolt, locking washer and washer.
- The 3/4” hole is the top rigging point and should stand off about 3”.
- Repeat this process on both side in all four positions.
Bumper Bar
To attach the bumper bar align the 3/4” holes on the top of the OFW bars and use the 3/4” bolts, washers, and nuts to secure the bar to the outer flyware.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>