URIKAR UR-SW01 LCD Monitor User Manual

URIKAR UR-SW01 LCD Monito

What’s In The Box

Introduction Of The LCD Monitor

1. LCD display
2. Turn On/Off key
3. Set target miles and time key”‘” and “v”
4. Battery life
5. Heart rate data
6. Battery life indicator light

How To Install The LCD Monitor

Step l. Install the monitor holder into the frame in the front of the exercise bike.

Step 2. The monitor holder should be fixed by tightening the four screw holes with a screwdriver shown below.

Step 3. Connect the Al wire to the pulse wire and connect the A2 wire to the sensor wire, then install the LCD monitor main body to the monitor holder. Please note: The A3 wire of the LCD monitor is a backup joint for keyboard expansion. It’ s not necessary to connect it if there is no need.

How To Set The LCD Monitor

After installing the LCD monitor, long-press the Turn On/Off key for 3 seconds to start it up. Once successfully, the LCD display will be on.

Long press the key “A” and “v” simultaneously to start the target miles and time settings. The contents you set will be shown in the picture below.

Short press the key “A” and” v” will increase from Oto 9, then short press the Turn On/Off key to jump to the next number and so on until the seventh number. The number will decrease by short pressing the” v” key. If you keep short pressing the” v” key, the number will jump to the next one and keep decreasing when it decreases to “0”.

• When the setup is completed, long-press the Turn On/Off key to exit.
• By short pressing the Turn On/Off key, the LCD monitor will be ready for use, then it will start recording the workout data while start pedaling.

Note:

1. If the pedals are not moved for 3 minutes on standby, the LCD monitor will gout;
2. If the pedals are not moved for 5 minutes during the exercise, the LCD monitor will go out and end your exercise without any information shown.
3. Short press the Turn On/Off key While exercising to end the exercise data recording;
4.  When not in use, long-press the Turn On/Off key for 3 seconds to turn it off.

Note:
LCD Monitor supports the NFC function. NFC offers a low-speed connection between devices. (Android 8.0 or above, and cell phone with NFC function, iPhone X above and excluding iPhone X, 1OS14 or above)

1. If the Urikar App is not installed, scan the NFC with your mobile phone, and you will automatically receive a notification to download and install the Urikar App.
2. lf the Urikar App is installed, and then scans the NFC with the mobile phone, the Urikar APP will automatically run and complete the Bluetooth connection between the mobile phone and the LCD Monitor.

Charging
How To Charge

Battery Life Indicator Light

1. When in use, the monitor gets a cycling signal, the green indicator light will be flashing; When the battery life is less than 10%, red indicator light will be flashing.

2. 2. During charging, red indicator light is solid on; when fully charged, blue indicator light is solid on.
   Note: When charging, if there is a charging error, the red indicator light will be flashing to note you the charging cannot be continued normally.

3. Please must fully charge the battery for the first charging time.

Specifications

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>