OXOMI 6902401-12 Shower Enclosures Installation Guide
- June 10, 2024
- OXOMI
Table of Contents
OXOMI 6902401-12 Shower Enclosures
Product Information
This product is a mounting kit with multiple components.
- Model: BV
- Types available: 75, 80, 85
- Kit includes:
- N21 B3.5×13-TX15 (7x)
- N60 6mm (3x)
- N100 4×35-TX20 (3x)
- N97 M5x35 (1x)
- 4384 (2x)
- 4307 (1x)
- 4106 (2x)
- 9264 (4x)
- 6337 (2x)
- 2.7mm (2x)
Product Usage Instructions
- Ensure that personal protective equipment is worn.
- Identify the type of mounting kit needed for the specific product and choose the appropriate type (75, 80 or 85).
- Use N21 B3.5×13-TX15 screws to attach the components to the mounting surface inside the product.
- Attach N60 6mm and N100 4×35-TX20 screws to the mounting surface inside the product.
- Attach N97 M5x35 screw to the mounting surface inside the product if needed.
- Use 4384 and 4307 components for mounting if needed.
- Use 4106 components for mounting if needed.
- Attach 9264 and 6337 components to complete the mounting process.
Note: Technical changes may be made to this product without prior notice. It is important to follow the installation instructions carefully to ensure proper usage.
We reserve the right to introduce technical changes without notice.
Installation by 2 persons is recommended!
Personal protective equipment is recommended!Shower
enclosures are intended for installation on shower trays. If installing
without a shower tray, the floor on which the shower enclosure will rest must
be flat and level. If installing on a joint or uneven surface, you must ensure
this is adequately siliconed to form a waterproof and maintenance-free seal.
When assembled off-floor or with a step, you must take appropriate measures to
prevent slip hazards on entry and exit. Before drilling the raw plug holes,
the wall has to be tested for concealed service pipes (electricity-, gas- or
water pipes). Drilling into these pipes is a life threatening hazard as well
as damage to property. Shower enclosures should be installed on solid walls
and bases. If installing on non-solid walls and bases, you must ensure
appropriate stability on site (e.g. by using special raw plugs). Please use
adequate and correct silicone appropriate for the installation (e.g. for
marble). Prior to installation please carefully examine shower enclosure for
transport or other damage. Thorough examination of all glass parts is
essential for your own safety. Seemingly minor damage may cause breakage of
glass and for this reason, extra care must be taken not to damage the glass
edges of the shower enclosure during installation or use of the shower
enclosure. Claims for transport damage after installation and claims for
damage or cost caused by incorrect installation, cleaning and maintenance will
not be paid.
Accessoires
Installation Instructions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>