AUTEL MaxiSys MS906 Pro Display Tablet User Guide
- June 6, 2024
- AUTEL
Table of Contents
AUTEL MaxiSys MS906 Pro Display Tablet
Thank you for purchasing this Autel MaxiSys MS906 Pro. Our tools are manufactured to a high standard and – when used according to these instructions and properly maintained – will provide years of trouble-free performance.
MaxiSys MS906 Pro Display Tablet
-
8-inch LED Capacitive Touchscreen
-
Ambient Light Sensor – detects ambient brightness
-
Power LED
-
Front Camera
-
Microphone
-
Collapsible Stand – extends from the back to allow hands-free viewing of
the table -
Rear Camera
-
Camera Flash
-
TF Card Slot
-
DC Power Supply Input Port
-
Mini USB Port
-
USB Port (for VCI Connection)
-
HDMI Port
-
adset Jack (3-band 3.5mm)
-
Lock/Power Button – press and hold to turn on/off the tablet, or tap to
lock the screen
VCI (Vehicle Communication Interface) Device – MaxiVCI V200
- Flashlight Power Butto
- Power LED
- Vehicle/Connection LED
- Vehicle Data Connector (16-pin)
- USB Port
VCI LED Description
LED|
Color
|
Description
---|---|---
Power LED
| Yellow| The VCI is powered on and performing self-check.
Green| The VCI is ready for use
Flashing Red| The firmware is updating.
Vehicle
/Connection LED
| Green|
- Solid Green: The VCI is connected via USB cable.
- Flashing Green: The VCI is communicating via USB cable.
Blue|
- Solid Blue: The VCI is connected via Bluetooth
- Flashing Blue: The VCI is communicating via Bluetooth.
| IMPORTANT: Before operating or maintaining this unit, please read these
instructions carefully, paying extra attention to the safety warnings and
precautions. Failure to use this product properly may cause damage and/or
personal injury and will void the product warranty
---|---
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation. Warning: Changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>