AUTEL MaxiSys MS906 Pro Diagnostic Tablet User Guide
- June 6, 2024
- AUTEL
Table of Contents
Quick Reference Guide
MaxiSys MS906 Pro
Email: sales@autel.com
Web: www.auteI.com
Thank you for purCh6SiFlQ this Autel MaxiSys MS906 Pro. Our tools are manufactured to a high standard and — when used according to these instructions and properly maintained — will provide years of trouble-free performance.
MaxiSys MS906 Pro Display Tablet
1. 8-inch LED Capacitive Touchscreen| 6. Collapsible Stand — extends from
the back to allow hands-free viewing of the tablet| 11. Mini USB Port
---|---|---
2. Ambient Light Sensor — detects ambient brightness| 7. Rear Camera| 12.
USB Port (for VCI Connection)
3. Power LED| 8. Camera Flash| 13. HDMI Port
4. Front Camera| 9. TF Card Slot| 14. Headset Jack (3-band 3.5mm)
5. Microphone| 10. DC Power Supply Input Port| 15. Lock/Power Button —
press and hold to turn on/off the tablet, or tap to lock the screen
VCI (Vehicle Communication Interface) Device — MaxiVCI V200
- Flashight Power Button
- Power LED
- Vehicle/Connection LED
- Vehicle Data connector (16-pin)
- USB Port
VCI LED Description
LED
| Color|
Description
---|---|---
Power LED
|
Yellow
| The VCI is powered on and performing self-check.
Green
| The VCI is ready for use.
Flashing Red
| The firmware is updating.
Vehicle /Connection LED
|
Green
| • Solid Green: The VCI is connected via USB cable.
• Flashing Green: The VCI is communicating via USB cable.
Blue
| • Solid Blue: The VCI is connected via Bluetooth.
• Flashing Blue: The VCI is communicating via Bluetooth.
IMPORTANT: Before operating or maintaining this unit, please read these instructions carefully, paying extra attention to the safety warnings and precautions. Failure to use this product properly may cause damage and/or personal injury and will void the product warranty.
- Insert the Vehicle Data Connector on the MaxiVCl V200 into the vehicle’s DLC, which is generally located under the vehicle dashboard.
2. 
- Ensure the tablet is sufficiently charged or is connected to the supplied DC power supply.
- Power up the tablet.
3. 
- NOTE: The tablet and the MaxiVCI V200 are configured to auto-matically synchronize with each other on first use, so there should be no need to pair up.
4. 
- When the MaxiVCl V200 is properly connected to the vehicle and the tablet, the VCI status button on the bottom bar of the screen will display a green badge with a check mark at the corner indicating the tablet is ready to start vehicle diagnosis.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>