ELBA ECF-K5605 56 Inch Ceiling Fan Owner’s Manual

ECF-K5605 56 Inch Ceiling Fan

ELBA CEILING FAN 56″
EOF-K3605(8K)
Owner’s Manual

Please read this manual carefully
before operating your set.

Retain it for future reference.
Record model number and serial
number of the set.

See the label attached on the set
and quote this information to your
dealer when you require service.

For The Warranty Terms & Conditions, Please Refer To Warranty Certificate.

IMPORTANT SAFEGUARDS

REMOVE ALL PACKING MATERIALS FROM THIS PRODUCT BEFORE USING IT. THIS
APPLIANCE MUST BE INSTALLAED BY A QUALIFIED TECHNICIAN. PLEASE
ENSURE THE ELECTRICITY SUPPLY TO THE APPLIANCE IS DISCONNECTED
BEFORE INSTALLING.

Please read this instruction carefully. It is advisable to keep this instruction manual in a
safe place for future reference.

1. Keep this appliance out of reach of children. Close supervision is necessary when the
   appliance is operating near children or infirm persons.

2. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the usage of this appliance by a person responsible for their safety.

3. Do not operate the appliance with damaged power cord or plug, after the appliance malfunctions, or if it was dropped or damaged in any manner. Kindly contact the nearest authorized dealer or after-sales service center for examinations, repairs, electrical or mechanical adjustments.

WARNING – to reduce the risk of fire, electrical shock or injury to persons or property, please read and follow below instructions careful

• The ceiling fan must be hooked on concrete ceiling. Do not install on plaster ceiling or any type of drywall ceilings. During installation, all screws must be tightened at all allocated parts.
• Always operate the product from a power source of the same voltage, frequency and rating as indicated on the product identification marking.
• Always switch off when not in use, before assembling or disassembling parts and before cleaning. Assemble the product completely before operating.
• Avoid continuous exposure towards direct wind flow from the ceiling fan, it may cause discomfort
• Do not hang on to the ceiling fan as it will cause the fan to drop and cause injuries
• Do not sprinkle water to the ceiling fan or do not wet the ceiling fan. Fire, explosion, short circuit and electrical shock can occur.
• This product should not be installed in a wet and high humidity area such as shower room. In the event of electrical current leakage, electrical shock and fire can easily occur.
• This product should not be installed in the immediate vicinity of open flame or other heating appliances where the likelihood of burning or high heat could occur,
• This product should not be installed at oily places. Fire, explosion, short circuit and electrical shock can occur.
• Avoid contact with moving parts. Do not touch the ceiling fan blades with any objects when the ceiling fan is spinning.
• Do not install the ceiling fan at places where there is high vibration and impact. The Possibility of ceiling fan dropping is high and will cause injury
• Do not operate it for purposes other than its intended use
• Always disconnect the product when relocating it
• The ceiling fan must be mounted above 2.5m from the floor and at least 1m from the wall to the fan blade.

To avoid injuries caused to users or any damage to properties, please

follow all the symbols with explanations written below.

|

A state that may be caused by the mishandling of products, which, if not avoided, may lead to the possibility of death or serious injury of users.

---|---
|

This sign warns of possible injury or damage to property.

|

This symbol indicates that the action is
COMPULSORY.

|

This symbol indicates that the action is PROHIBITED.

PRODUCT DESCRIPTION

1. Rubber Ring
2. Capacitor
3. Fan Blade
4. Shock Proof Washer
5. Upper Canopy
6. Suspension Rod
7. Lower Canopy
8. Motor Assembly

INSTALLATION GUIDE

Remove all the packaging materials from the box and ensure all components and
parts are complete.

ASSEMBLY OF FAN

1) Assemble the pulley, hook and pipe together as shown in the figure.

WARNING Do not use a modified pipe and ensure the hook is
attached securely to the pipe. This is to prevent
ceiling fan drops and injuries.

2) Slip the upper and lower canopies to the pipe.

 Do not tighten the screws.

3) Pass the cord and safety wire through the pipe
and insert the cord spring. Remove the safety wire
screw from motor shaft.

4) Place the cap on to the motor shaft. Proceed to
assemble the pipe with the motor shaft and secure
them in place using the bolt, plain washer, spring
washer, nut and cotter pin. Complete the assembly
by bending the cotter pin

Cotter pin must be fixed into the bolt and bent.
Can cause injury if ceiling fan drops.

5) Connect the pipe cords to the motor terminal.

6. Secure the cord as shown in the figure using insulock tie.

caution
Do not secure the safety wire with the insulock tie.

Loosened insulock tie and cords touching the
motor are not safe.

Will cause abnormal noise or ceiling fan to drop.
Can cause injury if ceiling fan drops.

7. Assemble the fan blades on to the motor and secure it
   firmly in place with the two blade screws. Repeat
   until all fan blades are assembled.

SUSPENSION OF FAN

Ceiling fan must be mounted above 2.5m from the floor and at least 1m from the wall to the blade.

Can cause injury if hit by blades. Ensure the ceiling hook is able to support at least 20 times the ceiling fan  weight. Can cause unstable air flow and affect ceiling fan to wobble.

The suspension hook must be on concrete ceiling.
Do not install on plaster ceiling or any type of drywall ceilings.
Do not fix inside the dome ceiling.

INSTALLATION OF SAFETY WIRE

1. Arrange and tie safety wire as shown above.

2. Ensure the safety wire is securely fixed onto the hanging hook. Tighten the safety
   wire screw onto the pipe.

Safety wire must be fixed correctly.
Can cause injury if ceiling fan drops.

INSTALLATION OF CANOPY

• With approximately 5mm distance from the ceiling, secure the upper canopy by
  tightening the screw.

• With approximately 7mm distance from the fan motor, secure the lower canopy
  by tightening the screw.

CONNECTION OF POWER SUPPLY

• This product is not provided with a cord and plug or any means of disconnection
  from the supply. To connect or replace the power cord or lead wire, ensure that it
  is done by a qualified personnel in order to avoid any hazards. Please use
  227IEC53(RVV) or thickness of tube is 1mm or above. (Other requirements such
  as diameter of lead wire, please use according to the country’s wiring regulation).

INSTALLATION_OF REGULATOR

1. Mount the regulator base on to the wall with screws.

2. Remove the regulator cover by loosening the screw. Insert the live
   wire from the wall through the hole of the base.

3. Connect the wires according to the circuit diagram above.

4. Reassemble the front cover to the base by tightening the screw.

FINAL CONFIRMATION

• Measure the distance using a measuring tape.

• Ensure that all the blades are of equal distance
  from the ceiling to the blade tip (within 1mm tolerance)

• Ensure that the screws, bolts and nuts are firm.

CLEANING AND MAINTENANCE

• Conduct checking on the fan condition at least once per year.
  If any problem occurs, stop using the fan immediately and refer to the nearest
  authorized dealer or after-sales service center for examinations, repairs, electrical
  or mechanical adjustments.

• Keep the fan clean regularly. Wipe away dirt with a clean soft cloth, mild soap and water.
  Ensure it is dry by wiping again. Do not use solvents (gasoline or petrol)

• Do not paint the blades. If damaged, order a brand new set of Blades (3 pieces)
  from the nearest authorized dealer or after-sales service center.

MAIN SPECIFICATION

Voltage: 220-240V~,50Hz
Rated Power: 90W
Fan Size: 56-Inch
Motor: 5-Speed

NOTICE

This product must not be disposed together with domestic waste. It has to be disposed at an authorized place for recycling of electrical and electronic appliances. By collecting and recycling waste, you help to save natural resources and make sure the product is disposed in an environmentally friendly and healthy way.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>