tc electronic 000-EBW00-00010 Zeus Drive Overdrive Pedal User Guide
- June 6, 2024
- tc electronic
Table of Contents
tc electronic 000-EBW00-00010 Zeus Drive Overdrive Pedal
INSTALLATION
- OUT – Send the signal to other pedals or a guitar amp via ¼” cable.
- 9 V DC – Connect a standard 9 V power supply (not included). The pedal does not accept batteries.
- IN – Connect your guitar via ¼” cable.
- DRIVE – Adjusts mix and clipping of drive circuit.
- LED – Lights when the pedal is engaged.
- VOLUME – Adjusts the output level when the pedal is engaged.
- FAT – Boosts the low frequencies and reshapes the mids, giving a fatter tone.
- TREBLE – Active tone control for the high frequencies. The center position is neutral, turning clockwise boosts highs, and turning counterclockwise attenuates highs.
- FOOTSWITCH – Press to engage or bypass the pedal.
Note – ZEUS Drive has 2 options for bypass type – buffered bypass and true bypass. Remove 4 screws on the side of the pedal and input/output nuts to access the internal bypass type selector switch.
Specifications
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street, Las Vegas NV 89118, United States
Phone Number: +1 702 800 8290
ZEUS DRIVE OVERDRIVE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Important information
Changes or modifications to the equipment not expressly approved by Music
Tribe can void the user’s authority to use the equipment.
Hereby, Music Tribe declares that this product is in compliance with Directive
2014/30/EU, Directive 2011/65/
EU and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH
SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK – 8200 Aarhus N, Denmark
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>