RHINO RH-WLD2021 Water Leakage Detector User Manual
- June 6, 2024
- RHINO
Table of Contents
RH-WLD2021 Water Leakage Detector
Water Leakage Detector User Manual
Product parameter:
Input voltage
DC3V AAA*2
Model Number:RH-WLD2021
Quiescent current
Alarm curren
Low-Voltage Indication
WiFi
Detection method
water sensor detection
Installation method
Mount on the ground
Working temperature
Working humidity
Please read this manual carefully before use, and keep it for future reference
How to Use:
indicator light flashes quickly to enter the automatic
until indicator light change to flashes slowly means into the manual network
configuration mode (compati-
choose the Smartlife_XXXX to connect the network
Water-Drop icon and enter the interface to start then device will sound di-di
alarming, the APP will show water leakage detected and received an alarm
Note: if both probe pins still in wet state or keeping
ONE YEAR MANUFACTURER WARRANTY:
The manufacturer warrants this product to be free from defects in workmanship
and materials, under normal residential use and conditions, for a period of
The manufacturer agrees, at its option during the warranty period, to repair
and defect in material or workmanship or to furnish a repaired or refurbished
return postage, and insurance which will be incurred
subject to verification of the defect or malfunction and proof of purchase as
confirmed by showing the model
WARRANTY LIMITATIONS This warranty does not include:
· Any condition resulting from incorrect or inadequate maintenance or care ·
Damage resulting from misuse, abuse, negligence, accidents or shipping damage
· Normal wear and tear · Damages incurred during transportation · Damages
incurred during assembly or maintenance · Any used, previously displayed items
FCC Compliance Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to
to provide reasonable protection against harmful
ment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference
guarantee that interference will not occur in a particu-
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
· Increase the separation between the equipment and
· Connect the equipment into an outlet on a circuit
Cet appareil contient des émetteurs / récepteurs
exemptés de licence conformes aux RSS (RSS)
d’Innovation, Sciences et Développement économique
Canada. Le fonctionnement est soumis auxdeux
–
Caution: Changes or modifications not expressly approved by the
conditions suivantes : (1) Cet appareil ne doit pas causer d’interférences.
party responsible for compliance could void your authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. The distance between user and products should be no less than 20cm.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles deprovoquer un
fonctionnement indésirable de l’appareil.
Canadian Compliance Statement
This device contains licence-exempt transmitter(s)/ receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licenceexempt RSS
(s). Operation is subject to the following two conditions: (1)This device may
not cause interference. (2)This device must accept any interference, including
interference that may cause undesired operation of the device.
This device complies with ISED RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device must be installed and operated with a minimum distance of 20 cm between the radiator and user body. Le présent appareil doit être installé et exploité à une distance minimale de 20 cm entre le radiateur et les corps.