PHILIPS 945579847 Infuse Ceiling Light User Manual
- October 27, 2023
- Philips
Table of Contents
PHILIPS 945579847 Infuse Ceiling Light
WHAT IN BOX
TOOLS REQUIRED
SPECIFICATION
INSTALLATION INSTRUCTION
SAFETY INSTRUCTIONS
The manufacturer advises the correct use of Luminaires (lighting fixtures)!
Therefore always follow these instructions to ensure correct and safe
installation and functioning of the luminalre and keep It for future
reference.Turn off electrical power at main fuse or circuit breaker box before
commencing installation, maintenance or repair. If in doubt. consult a
qualified electrician or contact your retail outlet. Ensure that you always
install the lumlnaire to the local electrical code. Certain regulations
indicate that luminaires should be installed by a qualified electrician.
Observe the correct color of the wiring before installation: white (N), black
(L) and green or bare copper wire (Ground). Do not connect this luminaire to a
non-grounded electrical system.
WARNING : Installing this fixture in a non-grounded electrical system
could allow metal parts of the luminaire to carry electrical current if any
wires or wire connections become broken or loose. Under this condition, anyone
coming in contact with the luminaire is subject to electric shock which could
cause injury or death. Always use wire nuts/connectors rated for the correct
gauge and number of wires used.
CAUTION : Be certain that no bare wire strands are exposed outside of the
wire nuts/connections (if applicable). Be careful not to damage or cut the
wire insulation (covering) during installation. Do not permit wires to contact
any sharp edges. Do not remove thermal insulation pad(s). Doing so will result
in increased temperatures and possible risk of lire. Maintain interior
lighting with a dry cloth duster, do not use abrasives or solvents.Avoid
liquid on all electrical parts. Always consider all the technical
specifications of the luminaire.Verify the stated icons on the ide11tification
label on the luminaire and the icons that are shown in part A of your safety
instructions.
ATTENTION : Below you will find all the explanations with numeric reference to
the icons respectively in front of these PART-B safety instructions.
Applicable icons to your fixture are shown in PART-A
- This product should only be installed indoors.
- The product is suitable for outdoor usage.
- Only suitable for . dry locations.
- Suitable for damp locations.
- Suitable for wet locations.
- Luminaire is suitable for base up mounting.
- Luminaire is suitable for base down mounting.
- Luminaire is suitable for horizontal mounting.
- The luminaire Is only suitable for fixing to the ceiling.
- The luminaire is only suitable for fixing to the wall.
- The luminaire is suitable for fixing to the wall and to the ceiling.
- Always observe the minimum distance between the lamp and the surface being lit as indicated on the icon.
- Free air space of at least 4 inches must be kept between top of shade and bottom of canopy.
- Immediately replace a cracked or broken safety glass and use only manufacturer approved parts.
- Strip the wire as indicated in the diagram. 16) Use heat-resistant cable for wiring the luminaire into the mains.
- MAX . … W: only use lamps suitable for this luminaire and keep within the maximum specified wattage.
- This product is not suitable for children under 14 years.
- The Luminaire has a ground conductor identified with green insulation or bare copper wire.
- The luminaire is only suitable for a lamp with built-in safety or a low pressure lamp. An extra safety glass is not necessary.
- The luminaire is equipped with a fuse. If the luminaire is out of order after the bulb has been replaced, the internal fuse has to be replaced. If contact with the internal wiring can be made during this operation, this should be done by a competent electrician.
- The luminaire can be used with a dimming circuit. Consult a qualified electrician for choosing the right type (especially important for low voltage luminaires).
- The Luminaire cannot be used with a dimming circuit.
- The luminaire is dimmable with the supplied dimmer ONLY. Do not connect to an additional dimmer.
- The dimmability features depend on the chosen lamp. More information on the dimmability features is available in the information pack provided with the bulb. 26)
- Luminaire with time and light setting options. Minimum and maximum will be shown in the icon in part A.
- The lumlnaire can be placed at a maximum of 20ft height.
- To reach an optimal working, you have to place the luminaire on the height mentioned in the icon.
- The maximum and minimum reach of the detector is also mentioned in the icon in part A.
- The standard active range of vision of the detector covers the given degrees mentioned in the icon.
- Ensure that you don’t drill through electrical wires or any other obstruction in the wall or ceiling during installation!
- This luminaire contains in some places very hot parts.
- Product to be installed by two people.
- To avoid corrosion, clean the luminaire a minimum of 2 times per year with a soft cloth and a neutral detergent. (4 times in coastal or industrial areas).
- The product is for indoor use only. Do not use in wet locations, areas directly exposed to water or outdoors.
- The product is ZigBee certified. Zigbee is an open standard for indoor wireless communication.
All Philips ZigBee Certified products can be connected with other Philips
ZigBee Certified products. 36) Bluetooth® enabled product. The Bluetooth® word
mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Signify is under license. Other trademarks and trade
names are those of their respective owners. Hue Personal Wireless Lighting is
a trademark owned by Signify Holding B.V. Please go to www.philips-hue.com to
learn more about Hue and how to use it.
This device complies with Part 15 of the FCC Rules and with RSS of Industry
Canada. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates. uses. and
can radiate radio frequency energy and. if not installed and used in
accordance with the instructions. may cause harmful interference to radio
communications.
This Class B digital apparatus complies with CAN ICES-005. This digital
apparatus does not exceed the class B limitsfor radio-noise emissions from
digital apparatus as set out in the Radio Interference Regulations of the
Canadian
Department of Communications.
NOTICE: Changes or modifications made to this device not expressly
approved by Signify North America Corporation (USA) and Signify Canada
Ltd/Signify Canada uee. (Canada) (collectively “Signify”) may void the U.S.
FCC and Canadian authorizatiion to operate this device. The advanced interface
module complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This device should be installed and operated with a
minimum distance of 20 centimeters between the radiator and your body. The
manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void
the user’s authority to operate the equipment. However, there is no guarantee
that interference will not occur in a particular installation. If this device
does cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver
- Connect the device into an outlet on a circuit different from that to which the receiver is connected. •
- Consult the dealer or an experienced radio/television technician for help.
Wireless Specification
- Wireless RF mode frequency band : 2400-2483.5 MHz
- Wireless communications protocol : IEEE 802.15.4
- Operating channels Zigbee : channels 11 – 26
- Operating channels Bluetooth : channels 0-39
LIMITED WARRANTY
Signify warrants that this device’s hardware components will be free from
defects in material and workmanship for a period of two (2) years from the
date of purchase, unless a different period is stated in or on the packaging
of the product, based on up to 3 hours average working time per day/7 days per
week, when used as directed (the “Warranty Period”). Notwithstanding the
foregoing, the Warranty Period for all Energy Star-certified products is three
(3) years from the date of purchase. This limited warranty only applies to the
hardware components contained in the original packaging. This limited warranty
does not apply to any software, even if packaged or sold with the hardware
components. Signify does not warrant that use of this device will be
uninterrupted or error-free. If this device does not conform to this limited
warranty, Signify will send you, at its election, a replacement device or
refund your original price upon receipt of the returned device, register
receipt and proof of purchase. Please call our toll-free number,
1-800-555-0050, or write to us (address indicated on the packaging) to find
out how to ireturn the device. This limited warranty does not cover devices
subject to accident. neglect, abuse, misuse or acts of God.
REPLACEMENT OR REFUND IS YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY
APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION
OF THIS LIMITED WARRANTY. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS
HEREBY EXPRESSELY EXCLUDED. Some states and provinces do not allow exclusion
of incidental or consequential damages, so the above limitation or exclusion
may not apply to you. This limited warranty gives you specific legal rights,
and you may also have other rights which vary from state to state and province
to province. This limited warranty is subject to, and may be superseded by,
our End of Support policy to the extent Signify decides to terminate support
for this device in accordance with its End of Support policy, available here:
www.philips-hue.com/endofsupportpolicy
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips N.V. Alterations in design and technical specifications reserved.
References
- Smart lighting | Philips Hue US
- End of Support Policy | Philips Hue US
- Philips - United States | Philips
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>