CORN MT202 Satelital Q Feature Phone User Manual

Satelital Q USER MANUAL

Overview

Charging the battery

• Before using the device for the first time, you must charge the battery to full.
• Connecting the charger improperly may cause serious damage to the device. Any damage caused by misuse is not covered by the warranty.
• After charging the device, ensure it is disconnected from the charging socket.
• The charger should remain close to the electrical socket and easily accessible while charging.

Safety Instructions

Please read there: mowing guidelines To view the full safety information please refer to the ttlealln and Safety’ from weer corn-monde corn

• Use manufacturer-approved batteries. chargers. accessories and supplies to prevent the risk of the trinity. Wear explosion.
• For pluggable equipment, the socket-outlet Shan be installed near the equipment and shall be easily accessible
• Risk of explosion d battery is replaced by an incorrect type Dispose of used batteries according to Mis instructions.
• Do not expose the device to phys cat impact or damage
• Avoid the charging Jack and battery terminals from contacting conductive elements such as metal and liquids.
• Do not store the device in very not or cola areas. It is recommended to use your device temperatures from 5 to SOC.
• Do not store your device near or in heaters, microwaves. cooking equipment or high-pressure containers.
• Donal touches the charger or the device with wet hands *nil° the device is charging.
• Denot uses your device outdoor during a thunderstorm.
• Turn off the device in potentially explosive environments
• Comply with all safety warnings and regulations regarding monde device usage while operating a vehicle.
• II the device is cracked, broken. or becomes very hot. slop using the device immediately lithe device haS a Camera flash or light, do not use 11 close to the eyes Of people Or eternal
• Your phone can cause interference with aircraft equipment Therefore, d M essential you follow airline regulations
• Never lake VOW 0014 apart. Unauthorized repair.) could break me terms of your warranty.
  GSM 8504900/180011900

To prevent possible hearing demegenhen using a headset. do not listen to sound at high volume for long periods.
Correct Disposal

(Waste Electrical & Electronic Equipment) this marking on the product. accessories or literature indicates that the product end ii electronic OCCOSSOneS(0 0 chargers, headset. US8 cable) should not be disposed of with household waste 0
This marking on the battery. manual or packaging indicates that the Pantiles in this product Should not be disposed of with other household waste.
FCC Warning:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The device complies with part 15 of the FCC Rules. Operation is subject to the following Iwoconditions!
(1)This device may not cause harmful interference. and
(2)This device must accept any interference received. including interference that May CauSe undesired Operation,
Note This equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate mass frequency energy and, if not installed and used in accordance with the instructions. may cause harmful interference to radio communications However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to lathe Or television reception. which can be determined by turning the equipment Oft and On. the user is encouraged 10 tries 10 COrreCt the interference by one or more of the following measures!

• Reenent or relocate the receiving antenna
• I increase this p.srallon between the equipment and receiver
  Connect the equipment into an outlet on a cipspl different from Mal to which the receiver is connected
  Consult the dateline( an espenanced Racho/TV technician for help
  SAR tests are conducted using standard operating positions accepted by the FCC with the phone Dan milting at its highest centralized power level in all tested frequency bands, although the SAR IS 0010ratined at the highOSICOrtItio0 again travel, the actual SAR level at the phone while operating can be well below the maximum value, in general, the closer you are to a wireless base station antenna, the lower the power Output BefOre a new Medal phone is available for sale to the public. it must DO tested and certified to the FCC Mal does not exceed The exposure limn established by the FCC. Tests for each phone are performed in positions and locabonste. o at the oaf and worn on the body) as required by the FCC.
  For body-worn operation. this model phone has been tested end meets the FCC RF exposure guidelines when used with an accessory designated for this product or when sued with an accessory that contains no metal and that positions the handset a minimum of 1.5 cm from the body.
  Noncompliance with the above restrictions may ‘exult in violations Of RF avow, guidelines.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>