CORN RS10 Mobile Phone User Manual
- June 5, 2024
- CORN
Table of Contents
CORN RS10 Mobile Phone User Manual
Overview
Installing the SIM card and battery
Charging the battery
- Before using the device for the first time, you must charge the battery to full.
- Connecting the charger improperly may cause servitors damage 10 the device. Any damage caused by misuse is not covered by the warranty
- Attar charging the device, ensure it is disconnected from 1he changing socket.
- The charge1 should remain close to the electrical socket and easily accessible wl1ile charging.
Safety Instructions
Please read the following guidelines To view the full safety information please refer to the “Health and Safety” from www.corn-mobile.com
- Use manufacturer approved batteries, chargers, accessories and supplies to prevent risk of injury, fire or explosion.
- For pluggable equipment , the sock el outlet shall be installed near the equipment and shall be easily accessible.
- Risk or ell plosion if teeth’ is replaced b)’ an connect type. Dispose or used batteries according to this instructions.
- Do not expose the device to physical impact or damage.
- Avoid he charging jack and battery terminals from contacting conductive laments such as metal and liquids.
- Do not store the de vice m very hot or cold areas. It 1s recommended to use your device temperatures from 5 to 50 C.
- Do not store your device near or in heaters, microwaves, cooking equipment or high-pressure containers.
- Do not touch the chirper or the device will watt hands while the device is charging.
- Do not use our device outdoor during a thunderstorm.
- Turn off the device in potentially close environments.
- Comply with all safety warnings and regulations regarding mobile device usage while operating a vehicle.
- If the device is cracked, broken. CH bicornes erhu, step using the device immediately. If the device has a camera flash or light, do not use it close to the eyes of people or animals.
- Your phone can case interference ‘Ajith aircraft equipment. Therefore. it is essential you follow airline regulations.
- Never take your phone apart. Unauthorized repairs could break the terms of your warranty.
- GSM :850/900/ 1800/1900 WCDMA:850/ 1900
To prevent possible of hearing damage when using a heads do not listen to sound al high volume for long periods.
Correct Disposal
(Waste Electrical & Electronic Equipment) this mark ing on the product. accessories or literature indicates that the produc1 and dielectronic accessorises (a g ch,irg8r, headset, USS cable) should not be disposed of with household waste.
This marking on the battery. manual or packaging indicates that the hat1eries in this product should not be clasped of with other household waste.
FCC Warning:
Any changes or modifications not expressly approved by the p.ir ty responsible for compliance could void the user’s authority to opera1e the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1 )This device may not cause harmful 1nterlerence, and
(2)This device must accept any ln1erference received, including in1erference
that may cause undesired operation.
Note: This equipment has been tested and found lo comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference m a installation. This equipment generates, uses and can radiate radio frequency energy and, if no1 installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there Is no guarantee that interference will not occur In a pellicular installation If this equipment does cause harmful interference to radio or television reception, which can he determined turning the equipment off and on. 1he user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
-In crease the separation between the equipment and receiver
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio / TV technician for help
SAR tests are conducted us ing standard operation pos1tions accepted by the FCC with the phone 1ransmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value, in general, the closer you ore too wireless Bose station antenna, the lower the power output.
Before a new model phone is available for sale to public, it must be tested and certified lo the FCC that does not exceed 1he exposure limit established by the FCC. Tests for each phone are performed in postilions and locations(e.g. at the ear and worn on the hoody) as required by the FCC.
For body worn operation, this model phone has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for t his product or then sued with an accessory that contains no metal and that positions the handset a minimum of 1.0cm from the body.
Non-compliance with the above restnct1ons may result m violations of RF exposure guidelines.
