SACKit Light 200 Outdoor Lamp User Manual
- June 6, 2024
- SACKit
Table of Contents
SACKit Light 200 Outdoor Lamp
THANK YOU!
Thank you for purchasing this SACKit Light 200 outdoor battery-powered lamp.
Please read this manual carefully before using your new lamp. We do not take
responsibility for personal injury or product damage caused by incorrect or
irresponsible use of the product. If you experience technical problems, you
can contact our customer service at info@sackit.dk.
We hope you will enjoy your new SACKit Light 200.
BOX CONTENTS
1 x SACKit Light 200 lamp
1 x Rope for hanging
1 x SACKit Battery Pack 7.800 mAh
1 x USB-C charging cable (adapter not included)
1 x Quick start guide
QUICK START GUIDE
- . Charge the lamp for a minimum of 8hours.
- Turn on the light clicking the Power button*.
- Select the desired light setting.
- Now enjoy the moment with the pleasant light.
- clicks in total from the time you turn on the light until you turn it off again.
NOTE: Turn off the lamp after use to extend battery life.
PRODUCT OVERVIEW
HOW TO USE SACKIT LIGHT 200
SACKit Light is switched on and operated by pressing the Power button (A).
*Saved Brightness:
When the lamp is on, you can set your own brightness at any time by pressing
and holding the ‘Power button’. When you hold down the button, the brightness
will change and either go towards a brighter or dimmer light. When you release
the button, this brightness will be saved as; ’Saved brightness’. This setting
will always be the first brightness at which the lamp is turned on.
NOTE: You can only save one brightness at a time.
CHARGING SACKIT LIGHT 200
The lamp is charged through the area (B). The LED (C) on the lamp will light
red when charging and green when fully charged
You charge the lamp by placing the magnetic end of the included USB cable on
the charging area (B).
NOTE :- As a minimum you need to use an USB adapter with the following
output: 5V/2A. – The battery pack is fully charge in 10 hours.
TROUBLESHOOTING
If you have trouble operating your SACKit Light 200 lamp, please try the
following solutions. If the following solutions do not solve your problem,
please contact our customer service at info@sackit.dk for further support.
There is no light when I turn on my SACKit Light 200
- Please check if the lamp has run out of power. If the lamp has run out, charge the battery pack for about 8 hours for a full charge.
My SACKit Light 200 flashes
- Please check if the lamp has run out of power. If the lamp has run out, charge the SACKit Light 200 for about 10 hours for a full charge.
I cannot charge/turn on my SACKit Light 200
- Please make sure that the adapter and the charging cable is connected correctly.
- Please check the power adapter voltage and current demand.
IMPORTANT SAFETY INFORMATION
Please read and follow the following instructions to ensure that you use the
SACKit Light 200 lamp safely and correctly. Product damage caused by use
contrary to the following information is not covered by the warranty.
Warning
To prevent any fires or electrical hazards please act according to the
following guidelines:
- Do not disassemble or replace any parts of this device. Please contact professional maintenance or a qualified service center if there is any damage to the device.
- Before the product is connected to a power supply socket, please ensure that the voltage of the power supply and the battery pack matches. If the voltage does not match, do not connect the battery
- ck to the power socket.
- Never charge the battery pack in or near water!
- Do not place the lamp too close to excessive heat or fire (such as a fireplace). However, the lamp can withstand up to 60 ° C and can withstand direct sunlight.
- The operating temperature of the lamp is between -20°C to 60°C.
- The charging temperature of the battery pack should be between 10 °C to 45 °C.
- This lamp is IP67 tight. This means it is dustproof and that it can be placed fully under water for a short period of time.
DISPOSAL OF THE PRODUCT
SACKit Light 200 is made from recyclable and high-quality materials. Do not
dispose of the lamp together with other living garbage. Please understand the
local guidelines for the disposal of electronics containing batteries. Correct
disposal of the lamp will help to prevent negative consequences for the
environment and health.
TECHNICAL SPECIFICATIONS
- Model: SACKit Light 200
- Max brightness: 245 lumens
- Light adjustment: 5 modes
- Battery: 7.800 mAh
- Battery time: 16 hours at 80% lumen
- Dimensions: Ø 30 cm
- Waterproof level: IP67
- Operating temperature: -20oC to 60oC
- Charging temperature: 10oC to 45oC
Contact your SACKit dealer if you experience problems and the lamp does not work. Never attempt to repair the lamp yourself.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>