SACKit 8583702 Light 300 Waterproof Lamp User Manual

June 6, 2024
SACKit

SACKit logo

SACKit 8583702 Light 300 Waterproof Lamp

SACKit 8583702 Light 300 Waterproof Lamp product

THANK YOU!
Thank you for purchasing this SACKit Light 300 outdoor battery-powered lamp. Please read this manual carefully before using your new lamp. We do not take responsibility for personal injury or product damage caused by incorrect or irresponsible use of the product. If you experience technical problems, you can contact our customer service at info@sackit.dk. We hope you will enjoy your new SACKit Light 300.

BOX CONTENTS

1 x SACKit Light 300 lamp
1 x Rope for hanging
1 x SACKit Battery Pack 10.400 mAh
1 x USB-C charging cable (adapter not included)
1 x Quick start guide

QUICK START GUIDE

  1. . Charge the lamp for a minimum of 10 hours.
  2.  Turn on the light clicking the Power button*.
  3.  Select the desired light setting.
  4.  Now enjoy the moment with the pleasant light.
  5.  clicks in total from the time you turn on the light until you turn it off again.

NOTE: Turn off the lamp after use to extend battery life.

PRODUCT OVERVIEWSACKit 8583702 Light 300 Waterproof Lamp img
1

HOW TO USE SACKIT LIGHT 300

SACKit 8583702 Light 300 Waterproof Lamp
img 2

SACKit 8583702 Light 300 Waterproof Lamp img 3

*Saved Brightness:
When the lamp is on, you can set your own brightness at any time by pressing and holding the ‘Power button’. When you hold down the button, the brightness will change and either go towards a brighter or dimmer light. When you release the button, this brightness will be saved as; ’Saved brightness’. This setting will always be the first brightness at which the lamp is turned on.
NOTE: You can only save one brightness at a time.

CHARGING SACKIT LIGHT 300

The lamp is charged through the area (B). The LED (C) on the lamp will light red when charging and green when fully chargedSACKit 8583702 Light 300
Waterproof Lamp img 4SACKit 8583702 Light 300 Waterproof Lamp img
5

You charge the lamp by placing the magnetic end of the included USB cable on the charging area (B).
NOTE :- As a minimum you need to use an USB adapter with the following output: 5V/2A. – The battery pack is fully charge in 10 hours.

TROUBLESHOOTING

If you have trouble operating your SACKit Light 300 lamp, please try the following solutions. If the following solutions do not solve your problem, please contact our customer service at info@sackit.dk for further support.
There is no light when I turn on my SACKit Light 300

  • Please check if the lamp has run out of power. If the lamp has run out, charge the battery pack for about 10 hours for a full charge.

My SACKit Light 300 flashes

  • Please check if the lamp has run out of power. If the lamp has run out, charge the SACKit Light 300 for about 10 hours for a full charge.

I cannot charge/turn on my SACKit Light 300

  •  Please make sure that the adapter and the charging cable is connected correctly.
  •  Please check the power adapter voltage and current demand.

IMPORTANT SAFETY INFORMATION

Please read and follow the following instructions to ensure that you use the SACKit Light 300 lamp safely and correctly. Product damage caused by use contrary to the following information is not covered by the warranty.
Warning
To prevent any fires or electrical hazards please act according to the following guidelines:

  •  Do not disassemble or replace any parts of this device. Please contact professional maintenance or a qualified service center if there is any damage to the device.
  • Before the product is connected to a power supply socket, please ensure that the voltage of the power supply and the battery pack matches. If the voltage does not match, do not connect the battery
  • ck to the power socket.
  • Never charge the battery pack in or near water!
  •  Do not place the lamp too close to excessive heat or fire (such as a fireplace). However, the lamp can withstand up to 60 ° C and can withstand direct sunlight.
  •  The operating temperature of the lamp is between -20°C to 60°C.
  • The charging temperature of the battery pack should be between 10 °C to 45 °C.
  • This lamp is IP67 tight. This means it is dustproof and that it can be placed fully under water for a short period of time.

DISPOSAL OF THE PRODUCT
SACKit Light 300 is made from recyclable and high-quality materials. Do not dispose of the lamp together with other living garbage. Please understand the local guidelines for the disposal of electronics containing batteries. Correct disposal of the lamp will help to prevent negative consequences for the environment and health.

TECHNICAL SPECIFICATIONS

  • Model: SACKit Light 300
  • Max brightness: 565 lumens
  • Light adjustment: 5 modes
  • Battery: 10.400 mAh
  • Battery time: 10 hours at 80% lumen
  • Dimensions: Ø 50 cm
  • Waterproof level: IP67
  • Operating temperature: – 20oC to 60oC
  • Charging temperature: 10oC to 45oC

Contact your SACKit dealer if you experience problems and the lamp does not work. Never attempt to repair the lamp yourself.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals