ETEKCITY EK7090 Digital Kitchen Scale User Manual
- June 6, 2024
- ETEKCITY
Table of Contents
- Specifications
- READ AND SAVE THESE INSTRUCTIONS
- Function Diagram
- Before First Use
- General Operation
- Replacing the Batteries
- Troubleshooting
- Warranty Information
- Terms & Policy
- Customer Support
- CUSTOMER SUPPORT
- SUPPORT HOURS
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
User Manual
Digital Kitchen Scale
Model: EK7090
Questions or Concerns?
MonFri, 9:00 am5:00 pm
PST/PDT support@etekcity.com
855-686-3835
Thank you for purchasing the Digital Kitchen Scale by Etekcity.
If you have any questions or concerns, please reach out to our helpful
Customer Support Team at support@etekcity.com. We hope you enjoy your new
kitchen scale!
Specifications
Weight Capacity | 176 oz / 11 lb / 5000 g / 5000 mL |
---|---|
Units | oz / lb:oz / fl oz (water/milk) / g / mL (water/milk) |
Increments | 0.05 oz / 1 g / 1 mL |
Auto-Off | 3 minutes |
Battery | 3 x 1.5V AAA batteries |
Dimensions | 7.9 x 5.6 x 0.5 in / 200 x 141 x 12.5 mm |
READ AND SAVE THESE INSTRUCTIONS
Important Safety Information
To avoid damage to this scale, please read and follow all instructions and
safety guidelines in this manual.
Scale
- Do not exceed the 11 lb / 5000 g weight capacity as it will damage the scale. An error indicator will appear on the LED display if the limit is exceeded.
- Do not immerse the scale in water or any liquid. If the liquid is spilled on the digital display or buttons, immediately wipe the scale clean with a soft cloth to avoid internal damage.
- Handle with care. This scale is not intended for commercial or heavy-duty use.
- Keep the scale in a cool, dry place. Avoid exposure to damp environments or extreme temperatures.
- Household use only.
Batteries
- Do not mix new and old batteries.
- If the low battery indicator (“Lo”) appears on the display, replace the batteries.
- If the scale is not in use for an extended period of time, remove the batteries to conserve battery life and extend the lifetime of the scale.
Function Diagram
A. Unit Selection Button
B. LED Display
C. Power/Tare Button
D. Anti-Skid Pads
E. Battery Compartment
Before First Use
The batteries are pre-installed in the scale.
- Turn the scale over and open the battery compartment.
- Remove the plastic strip from the battery compartment. [Figure 1.1]
- Replace the battery compartment cover.]
- Turn the scale over again and place on a hard, dry, flat surface.
- Tap to turn on the scale.
Using Your Scale
Note:
- For accurate results, always place the scale on a hard, dry, flat surface, and keep the scale away from dirt, dust, vibrations, wind, air currents, and electromagnetic interference.
- When you turn on the scale, choose units, or use the tare function, wait for the scale to read ” ” again before measuring.
General Operation
- Place the scale on a hard, flat, level surface for measurement.
- Tap to turn on the scale. Make sure the scale shows ” “. Tap UNIT to select your desired measuring unit, which will show on the right of the display.
- Place your item on the scale.
- Wait for the reading on the display to stabilize.
Unit Conversion
To change the unit of measurement, tap unit the display shows the desired
unit of measurement.
Automatic Power Off
To save battery power, the scale will automatically power off after 180
seconds of inactivity
Manual Power Off
Press and hold for 2 seconds to turn off the scale.
Zero / Tare Function
Whenever you measure items inside a container, you can use the tare
function to remove the container’s weight from the final measurement.
- Tap to turn on the scale. Make sure the scale shows ” “. If the screen does not display “ ” automatically, tap to auto-adjust to zero.
- Place the container on the center of the scale.
- Wait for the reading on display to stabilize. The screen will display the container’s weight.
- Tap to tare the weight of the container. The screen should now display ” “.
- Place the item in the container. The scale will measure the liquid or items, without including the weight of the bowl. [Figure 2.1]
- When you’re done, reset the scale by removing all weight and tapping again.
Replacing the Batteries
- Turn the scale over and open the battery compartment.
- Take out the used batteries and replace them with 3 new 1.5V AAA batteries.
- Replace the battery compartment cover.
Troubleshooting
Problem | Possible Cause |
---|---|
The scale does not turn on. | Open the battery compartment cover and remove the |
plastic strip.
Replace the batteries (see page 10).
Make sure batteries are inserted under the correct polarity as marked on the
battery compartment.
Reading is inaccurate.| Place scale on a level surface.
Make sure the screen displays ” ” before measuring (see Zero / Tare Function,
page 9).
Remove the batteries for 45 seconds, then replace them to reset the scale.
The display shows ” “| Item is too heavy. Remove item from scale to protect
its weight sensors. Use a different scale with a higher weight range.
The display shows ” “| Turn the scale off and on again. Avoid moving the scale
while measuring.
The display shows ” “| Battery power is low. Replace the batteries (see page
10).
If your problem is not listed, please contact Customer Support (see page 14).
Warranty Information
Product | Digital Kitchen Scale |
---|---|
Model | EK7090 |
Default Warranty Period | 2 years |
For your own reference, we strongly recommend that you record your
order ID and date of purchase.
Terms & Policy
Etekcity Corporation (“Etekcity”) warrants this product to the original
purchaser to be free from defects in material and workmanship, under normal
use and conditions, for a period of 2 years from the date of original
purchase.
Etekcity agrees, at our option during the warranty period, to repair any
defect in material or workmanship or furnish an equal product in exchange
without charge, subject to verification of the defect or malfunction and proof
of the date of purchase.
There is no other express warranty. This warranty does not apply:
- If the product has been modified from its original condition;
- If the product has not been used in accordance with directions and instructions in the user manual;
- To damages or defects caused by accident, abuse, misuse, or improper or inadequate maintenance;
- To damages or defects caused by service or repair of the product performed by an unauthorized service provider or by anyone other than Etekcity;
- To damages or defects occurring during commercial use, rental use, or any use for which the product is not intended;
- To damages or defects exceeding the cost of the product.
Etekcity will not be liable for indirect, incidental, or consequential damages
in connection with the use of the product covered by this warranty. This
warranty extends only to the original consumer purchaser of the product and is
not transferable to any subsequent owner of the product regardless of whether
the product is transferred during the specified term of the warranty.
This warranty does not extend to products purchased from unauthorized sellers.
Etekcity’s warranty extends only to products purchased from authorized sellers
that are subject to Etekcity’s quality controls and have agreed to follow its
quality controls.
All implied warranties are limited to the period of this limited warranty.
This warranty gives you specific legal rights and you may also have other
rights which vary from state to state. Some states do not allow the exclusion
or limitation of incidental or consequential damages, so the above limitation
or exclusion may not apply to you.
If you discover that your product is defective within the specified warranty
period, please contact Customer Support via
support@etekcity.com. DO NOT dispose of your
product before contacting us. Once our Customer Support Team has approved your
request, please return the product with a copy of the invoice and order ID.
Every Etekcity product automatically includes a 2-year warranty. To make the
customer support process quick and easy, register your product online at
www.etekcity.com/warranty.
This warranty is made by:
Etekcity Corporation 1202 N. Miller St., Suite A Anaheim, CA 92806
Customer Support
If you encounter any issues or have any questions about your new product, please contact our helpful Customer Support Team. Your satisfaction is our goal!
CUSTOMER SUPPORT
Etekcity Corporation 1202 N. Miller St., Suite A Anaheim, CA 92806
Email: support@etekcity.com
Toll-Free: 855-686-3835
SUPPORT HOURS
MonFri, 9:00 am5:00 pm PST/PDT *Please have your order invoice and order ID ready before contacting Customer Support.
Connect with us @Etekcity
Building on better living. 01.01_D_21I06_us
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>