SONOS Arc Wall Mount Kit User Guide
- June 6, 2024
- Sonos
Table of Contents
SONOS Arc Wall Mount Kit
Wall mount
Guidelines
- Use the Sonos Arc wall mount kit. You can buy it on www.sonos.com. Follow the instructions in the kit.
- Keep 4.0″ (102 mm) space (minimum) between Sonos Arc and your TV.
- Make sure the touch controls are facing up.
- For best sound quality, keep both ends of Arc at least 1′ (30cm) from a wall or other obstruction.
Mount kit contents
- Wall mount bracket
- Positioning guide (don’t discard—it may look like packing material)
- 2 knobs
- 6 wall anchors
- 6 screws
Note: Don’t discard the positioning guide. It may look like packing material.
If your TV is wall-mounted, place the positioning guide against the wall, aligning the top edge with the bottom of your TV. There should be 5.5″ (140 mm) between the top of the wall mount bracket and the TV.
Mark the screw locations and remove the guide. Refer to Wall mounting information for placement help.
If you’re using the included wall anchors, use a 5/16″ drill bit to drill the pilot holes and then insert the wall anchors. Don’t use the anchors if you’re drilling into wood or plastic.
Position the wall mount bracket over the marked screw locations, using a level to confirm accuracy. Use a Phillips-head screwdriver or a power drill to screw the bracket to the wall, making sure the arrows in the center are pointing up.
Screw the 2 knobs into the back of the soundbar until they are fully tightened.
Connect the power
and HDMI cables to the back of the soundbar.
Note : If you’re connecting the cables to the TV at this time, be sure to
plug the HDMI cable into the HDMI ARC or eARC port on your TV.
Slide the soundbar down so the knobs fit into the slots on the wall bracket. Make sure the touch controls are facing up, and the soundbar is fully seated.
Wall mounting information
Wall mounting information|
---|---
Wall Material| Pre Drill| Use Wall Anchors| Use Screws
Wood Stud| 1/8″ / 3 mm bit| No| 2
Drywall (no stud)| 5/16″ / 8 mm bit| Yes| 6
Plaster| 5/16″ / 8 mm bit| No, requires toggle bolt (not included)| 2-6
Concrete or Brick| 5/16″ / 8 mm bit| Yes| 2-6
| | |
Specifications
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>