EIKON EKBMG01 Microphone Tablettop Stand User Manual
- June 6, 2024
- EIKON
Table of Contents
MICROPHONE TABLETOP STAND
EKBMG01
USER’S MANUAL
Thank you for choosing one of Eikon products, and for your confidence towards our brand, synonymous of professionalism, accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in professional installation systems.
Description
Microphone stand in plastic material with ON/OFF switch and status indicator screen led. The internal metallic reinforcement ensures the maximum stability when used.
- XLR-3 microphone connector
- XLR-3 output microphone connector
- Suitable for electret microphone with gooseneck (+ 3V Power output)
Nota: a phantom power supply or two 1,5 volt AA alkaline batteries is
necessary for a correct operating mode (when using the phantom power supply,
move the switch located under the base to the OFF position).
Apparatus in compliance with CE standards
Precautions
To reduce the risk of electric shock do not remove cover (or back panel). No
user serviceable parts inside. Refer servicing to qualified personnel only.
To reduce the risk of fire or electric shock, do not expose this apparatus to
rain or moisture.
- Before the unit use and installation, read carefully all safety and operating instructions contained in the present user manual. Such manual should be retained for future reference.
- Attention: incorrect installation could damage irrevocably the unit.
- Any use not complying with technical specifications could reduce the unit performance.
- In case of use in presence of children, ensure that the unit does not implicate perils.
- Ensure to set the unit far away from atmospherical agent, wet ambient or ambient with high humidity levels.
- Do not keep the unit close to heat sources.
- Be careful that no liquid is spilled inside the unit.
- For service purposes, ensure to apply to qualified persons.
Installation
-
Insert the gooseneck connector in the stand XLR connector. Ensure when introducing the gooseneck to hear a “click” and to make reference to the following illustration.
-
Connect the call station microphone to the amplifier throughout the following cable (XLR male/XLR female).
-
Set ON position for Mixer/Amplifier phantom alimentation.
-
Pressing the microphone stand key, the screen led show ON and it is possible to make announcements. The following key pressing disable the microphone stand and the screen led show OFF.
-
To disconnect the gooseneck microphone, keep strongly the stand, low the tang (illustrated in below figure) and extract the microphone.
Connections:
Balanced connection:
Is a brand of
PROEL S.p.A.
(World Headquarters – Factory)
Via alla Ruenia 37/43 64027 Sant’Omero (Te) – Italy
Tel: +39 0861 81241
Fax: +39 0861 887862
www.eikon-audio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>