OMEGA OS306-Series Infrared Thermometer User Guide
- June 6, 2024
- Omega
Table of Contents
OMEGA OS306-Series Infrared Thermometer
Battery Installation
-
Locate the notches on the side of the unit’s handle and pull the front of the handle forwards as shown above.
-
Attach a 9V battery (provided) to the black connector inside. The battery should snap into place. Swing the front of the handle back upwards to close the unit.
How to turn on the unit
- Press the trigger of device to power on
Quick Measurement
- Point thermometer at a target surface
- Pull and hold the trigger to begin scanning
- Release the trigger to stop scanning
- The data will be held for 30 seconds then the unit will power off
Switch between Celsius and Fahrenheit
The default setting for the temperature unit is in Celsius. Please follow the below steps to change the temperature units to Fahrenheit.
- Press the “°C °F” Button
- You should now see the temperature displayed in ⁰F (Fahrenheit)
Field of View
- This unit has a distance ratio of 12:1
- When measuring a surface 300 mm away, a 25 mm area will be measured.
Contact Information
If you need technical support, please call 1-888-826-6342.
Documents / Resources
|
OMEGA OS306-Series Infrared
Thermometer
[pdf] User Guide
OS306-Series, OS306-Series Infrared Thermometer, OS306-Series, Infrared
Thermometer
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>