OMEGA OS310-Series Infrared Thermometer User Guide
- June 6, 2024
- Omega
Table of Contents
OS310-Series
OS-310-501 QUICK Start Guide
Battery Installation
1. Locate the notches on the side of the unit’s handle and pull the front of the handle forwards as shown above. ****
2. Attach a 9V battery (provided) to the black connector inside. The battery
should snap into place. Swing the front of the handle back upwards to close
the unit.
Note: Positive side of the battery has a “+” mark and the negative side
has a “–“ mark on the battery label.
How to turn on the unit
Press the trigger of the device to power on
Quick Measurement
- Point thermometer at a surface
- Pull and hold the trigger to begin scanning
- Release the trigger to stop scanning
- The data will be held for 20 seconds, and then the unit will power off
Switch between Celsius and Fahrenheit
The default setting for the temperature unit is Celsius. Please follow the
below steps to change the temperature units to Fahrenheit.
- Press the °C °F Button
- You should now see the temperature displayed in ⁰F (Fahrenheit)
Field of View
- This unit has a distance ratio of 50:1
- When measuring a surface 50 cm away, a 1 cm area will be measured.
Contact Information
If you need technical support, please call 1-888826-6342.
omega.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>