MooKa B-D02L True Air Purifier User Manual
- June 6, 2024
- MooKa
Table of Contents
- IMPORTANT SAFEGUARDS
- IMPORTANT SAFEGUARDS
- TECHNICAL FEATURES
- PRODUCT INTRODUCTION
- PRODUCT INTRODUCTION
- USE AND OPERATION
- REPLACING THE FILTER
- SAFETY TIPS
- USING THE APPLIANCE
- USING THE APPLIANCE
- USING THE APPLIANCE
- USING THE APPLIANCE
- USING THE APPLIANCE
- TROUBLESHOOTING
- TECHNICAL PARAMETERS
- WARRANTY
- CONTACT US
- CUSTOMER SERVICE
- Documents / Resources
Air Purifier
User Manual
| High Clean Air Delivery Rate
---|---
| 3-Stage Filtration System
| Low Noise Level
| Child Lock
IMPORTANT SAFEGUARDS
Please follow the further recommendations to avoid personal injury or product damage.
WARNING/ATTENTION
WARNING
Please read the important safeguards carefully before using this appliance
ATTENTION
It reminds us that misusing or mishandling may cause hurt.
FORBID
The operation cannot be performed or forbidden.
|
FORCE
A certain operation should be performed (mandatory).
IMPORTANT SAFEGUARDS
**WARNING**
Please supervise your children and avoid them from touching or using
appliances.
Do not handle the plug with wet hands. It may cause electrical shock.
Do not disassemble, repair, or reconstruct the appliance.
It may cause an electric shock, fire hazard, or getting an injury. Contact
the authorized retailer for item repairing.
Check if the voltage indicated on the appliance corresponds to the
local power voltage before you connect the appliance. Other electric
appliances used simultaneously may cause the socket to be hot or cause a
fire.
TECHNICAL FEATURES
DEODORIZING PERFORMANCE
*Pre-filter, HEPA filter
Activated carbon filter removes formaldehyde, benzene, xylene, toluene, TVOC,
and other harmful gases effectively.
Low resistance H13 HEPA filter traps 99.97 percent of tiny particles or
droplets in the air that are two and one-half microns or less in width.
FILTRATION PROCESS DIAGRAM
PRODUCT INTRODUCTION
MOOKA AIR PURIFIER WITH H13 HEPA AIR FILTER DIAGRAM
PRODUCT INTRODUCTION
CONTROL PANEL DIAGRAM
USE AND OPERATION
GETTING STARTED
Do not block the air inlet and outlet, e.g. by placing items on the air outlet
or in front of the air inlet closer than 30cm.
Make sure that foreign objects do not fall into the air purifier through the
air outlet.
Do not use the appliance in wet areas or in surroundings that are high ambient
temperature.
FILTER
The filter should be replaced every 3-6 months.
Fan speed indicator flashes when the filter replacement is needed.
After the filter has been replaced, press and holds the fan speed button for 3
seconds to reset the filter lifetime counter.
Removing the filter
- Switch the appliance off and unplug it.
- Invert the equipment.
- Rotate the base cover counter-clockwise to take out the filter.
- Remove the filter as soon as the base cover will be opened.
REPLACING THE FILTER
Installing the filter
- Please remove the new filter protective film before installation.
- Rotate the base cover clockwise properly until the filter is installed securely.
EXTERNAL POWER SOURCE
DC Adapter
SAFETY TIPS
Make sure the filter is installed properly before switching the appliance on. A large amount of dust may cause malfunctions.
Do not use a power adapter that is not compatible with the product.
Check if the voltage indicated on the appliance corresponds to the local power voltage before you connect the appliance.
Please check if the appliance is securely connected to the power socket before use.
In case of a power outage:
- Unplug the AC plug out of the power adapter.
- Unplug the DC plug out of the unit.
USING THE APPLIANCE
POWER SETTING
– After power-on, all lights on the display screen are on for self-check After
the self-inspection is completed, all the displays are off and enter the
standby state.
– In standby mode, touch the top power switch to turn on, the wind speed key
is on by default after power on, and the low-speed indicator is on. The fan
runs at low speed and the atmosphere light is on. Touch the top power switch
again to turn off and the machine enters the standby state.
USING THE APPLIANCE
– When the air purifier is powered on, press and hold the “Backlight” button for 3 seconds to turn the backlight off. Proceed the same procedure to turn the backlight on.
Note: the backlight does not correlate with the night mode features.
SETTING FAN SPEED
Briefly press the “Fan Speed” button to set the required fan speed level.
Press again to switch the fan speed level. Adjust the fan speed level
according to the order depicted below.
USING THE APPLIANCE
SLEEP MODE
The air purifier filtration speed is adjusted to the lowest airflow speed.
After the sleep mode was set, the light intensity of the appliance will be
switched off in 10 seconds.
Note: Timer cannot be applied to sleep mode.
USING THE APPLIANCE
TIMER
Use the “Timer” button to set the appliance operating duration. Press the
‘Timer’ button to pick the required duration of operating time (1, 2, 4, or 8
hours). The air purifier shuts off automatically at the end of the selected
period.
CHILD LOCK
Press and hold the ‘Timer” button for 5 seconds to activate the child lock.
The child lock symbol ” ” lights on. When the child lock is on, none of the
buttons are responsive. Press and hold the ‘Timer” button for 3 seconds again
to deactivate the child lock.
USING THE APPLIANCE
MEMORY FUNCTION
Your fan speed and backlight settings remain the same in case of a power
outage.
But the picked operating duration will be reset.
TROUBLESHOOTING
If the appliance works not properly please check the most common problems you could encounter at the table below.
Problem | Possible solution |
---|---|
The appliance does not work | Please check if the power cord is plugged into |
the socket properly.
Please check if the base is installed properly.
Odor cannot be removed.| Check if the filter is installed properly. Please
ventilate the operating area before purifying.
The filter is dirty. Please replace the filter.
The appliance is loud during the operation.| Please check if the filter
protective film is removed.
The filter is dirty. Please replace the filter.
TECHNICAL PARAMETERS
If the problem cannot be solved according to the information above, please contact the authorized retailer for item repairing.
Model No.: B-DO2L
Power supply: DC 24V/1A
Net Weight: 3.52 LB
Noise level dB(A): 520dB(A)
Power consumtion (W): 16W
Dimensions (wxdxh): 180x 180×292(mm)
Multi-function filter
Size: 135×135*145 (mm)
Life time: 3-6 months
WARRANTY
- MOOKA warrants the included hardware product and accessories for 12 months from the original date of retail purchase. If you want to extend your warranty for 12 more months, please do not hesitate to contact us.
- Become a MOOKA member and get access to exclusive benefits, such as updates about the latest MOOKA products.
CONTACT US
Please scan the QR-code to start chatting (Live chat).
CUSTOMER SERVICE
Our customer service team is standing by to assist you if you have any questions or concerns.
Scan the QR-code to start chatting (live chat):
Scan OR-code & Start Chatting
http://m.me/MookaShops
or
warranty.mookashops.com
1-855-666-9955
support@mookashops.com
www.mookashops.com
Beyond Elegance
Made in China
Documents / Resources
|
MooKa B-D02L True Air
Purifier
[pdf] User Manual
B-D02L, True Air Purifier
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>