RDKS S10 Pressure Sensor for Tire Owner’s Manual
- October 27, 2023
- RDKS
Table of Contents
**RDKS**
S10 Pressure Sensor for Tire
Owner’s Manual
Safety Instructions
Please read this manual carefully before using the product, be familiar with the structure of the product and master the installation method of the product. Before installation, please confirm that the product accessories are complete, the product can work normally, and there is no abnormal appearance and structure. During the installation process, the company shall strictly abide by the maintenance operation specifications and use professional maintenance tools. Otherwise, the company will not be responsible for any problems caused by the customer’s illegal operation. If there is any problem in the process of using the product, it must be replaced or stopped immediately and tested by professional maintenance personnel or after-sales service. After installing the product, be sure to re-measure the dynamic balance of the tire to eliminate safety risks
Parameters:
Product ModelS10-Sensor
Storage temperature-10~50
Operating temperature-40~125
Pressure monitoring range0-800Kpa
Waterproof gradeIP67
Battery life4-6years
TPMS Power Level5-8dBm
TPMS Frequency433.92MHz & 315MHz
NFC Tags Frequency13.56MHz ± 7KHz
NFC Tags RF Speed 26Kbps
Pressure accuracy±7Kpa
Temperature accuracy±3
Weight: 28g With valve
Dimensionsapprox.51.4mm27.8mm13.5mm
Warranty: 2 years
Sensor Component diagram
- Tire pressure sensor
- Sensor setting screw
- Metal valve mouths
- Valve retaining nut 5 : valve cap
Installation Operation Steps
Step 1: Pass the nozzle through the hub and fix it with the nozzle fixing nut.
Note that it is not tightening.
Step 2: Fix the sensor on the air nozzles with the sensor fixing screw. Note
that the sensor should be close to the hub with a torque of 4N·m.
Step 3: Tighten the air nozzle fixing nut with a wrench to complete the
installation. Note that the wrench uses a torque of 7N·m.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>