KYUNG IN KRC-T401RC Hej home Smart Relay Controller User Manual
- June 6, 2024
- KYUNG IN
Table of Contents
KYUNG IN KRC-T401RC Hej home Smart Relay Controller User Manual
Summary
Wireless switch product that connects to Zigbee and able to control an Automation scenario of 12EA in total.
Product specification
Product dimensions
ITEM
|
DESCRIPTIONS
---|---
Model
|
KRC-T401RC
Protocol
|
Zigbee 3.0
Size
|
52mm 52mm 10mm
Battery
|
CR2032
Battery Lifetime
|
1 Year
Operation Temp.
|
0℃ ~ 60℃
Shape and name of product
Pic 1 [Front of product]
Pic 2 [Rear of product – Internal battery cover]
Pic 3 [Rear of product]
Method of use
Product functions
Set the app-registered product or automation scenario control trigger with ‘Single click’, ‘Double click’ and ‘Long click(3 seconds)’ for each of the four buttons to perform up to 12 actions maximum.
Product Interlink / Reset
- Log in to the TUYA app, register the Zigbee sensor hub and click “Add Product” at the bottom of the sensor hub UI.
- After put SMART REMOTE close to Zigbee sensor hub and press #3 buttons together for 5 seconds of SMART REMOTE.
- Once the status light blinks, take your hands off from the button.
- If the status light blinks quickly, the product successfully entered the interlocking mode.
- When the product link is successfully completed, the status light turns off and the product is added to the app.
- If you reset the product physically, go back to ‘A’ and proceed in the same order.
Action registration method into buttons.
- Click the icon of SMART REMOTE added to the app, specify the button at the top of the UI to add the action and click “ADD Scene” at the bottom.
- Click “Edit Name” to set the name of the action.
- When the name setting is completed, click “Add condition” at the bottom and select the trigger for the action among of “Single Click”, “Double Click”, “Long Press”
- When the action trigger selection is completed, click “Add action” at the bottom of Perform Actions and select action you want to run as a trigger among of “Perform Scene”, “Automation”, “Devices”
- When registration is completed, click the button and run the action.
The status light blinks once when you click the button.
FCC Warning Statement
FCC Part 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Part 15.21
Any changes or modifications (including the antennas) to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC Radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>