Kyung In Electronics KES-T202ES Smart Relay Controller 2 Channel Instruction Manual
- June 6, 2024
- Kyung In Electronics
Table of Contents
Kyung In Electronics KES-T202ES Smart Relay Controller 2 Channel
Instruction Manual
Product feature
- Remote control at any time, anywhere through TUYA APP.
- Individual control and batch control of all Channels connected to the RELAY switch (App control).
- The schedule function turns on and off at a user-specified time.
- Control 2 CHANNEL AC with one product.
Product specification
Product dimensions
| ITEM | DESCRIPTIONS |
|---|---|
| Model | KES-T202ES |
| Protocol | Zigbee 3.0 |
| Size | 167mm 74mm 15.5mm |
| Power specification | AC 100~ 240V/ 60Hz |
| Communication distance | Within 10m from Zigbee Gateway |
| Operating temperature | 0℃ ~ 60℃ |
| Power consumption | 0.4W |
Shape and name of the product
- AC INPUT: AC, WIRE
- AC OUTPUT (CHANNEL 1, CHANNEL 2)
- OUTPUT STATUS DISPLAY LED
- Pairing STATUS DISPLAY LED
- CH1, CH2: Output on/off Button, Pairing Button double purpose( Press for 5 seconds)
- External Pairing Button or External Pairing Status Display Led Connector
Connection wiring diagram
Installation precautions
-
Using it for home use is recommended.
-
Turn off the light breaker and install it.
-
When installing a shopping mall or office, you need to check the capacity of the light.
(Unable to install when capacity is exceeded.) -
The location of the product installation is recommended to be put as near as possible in the field of view.
If the product cannot be registered, please open the door or put the Zigbee Gateway closer. -
Beware not to be contacted with the product with conductive material.
-
There is a risk of fire or a short circuit if installed near the heating product.
-
Beware the product not to be contacted with water or moisture.
-
This product is an AC electric product, so please install it by an electrician when installing it.
-
Please install it in order not to be the wire sheath exposed.
-
Do not expose the sheath of the wire.
Product functions
- Using a physical switch, able to 2 Channel On/Off
- Using an App, able to On/Off
Product Interlink / Reset
A Login to the TUYA app, register the Zigbee sensor hub and click “Add
Product” at the bottom of the sensor hub UI.
B After putting the Relay board close to the Zigbee sensor hub and press
the ch1 button for 5 seconds.
C Once the status light blinks, take your hands off from the button.
D If the status light blinks quickly, the product successfully entered
the interlocking mode.
E When the product link is successfully completed, the status light turns
off and the product is added to the app.
F If you reset the product physically, go back to ‘A’ and proceed in the
same order.
G Per CHANNEL in APP, when ON/OFF the RELAY operates.
FCC Warning Statement
FCC Part 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Part 15.21
Any changes or modifications (including the antennas) to this device that is
not expressly approved by the manufacturer may void the user’s authority to
operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located
or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>