LUX PRO LP600V3 High-Output Small Handheld LED Flashlight User Manual

: June 6, 2024
: LUX PRO

Table of Contents

Features
Operation Instructions
Battery Replacement
Product Warranty
Read User Manual Online (PDF format)
Download This Manual (PDF format)

USER MANUAL
LP600V3
High-Output Small Handheld
LED Flashlight

Features

Constructed with aircraft-grade aluminum
LPE optics
Patented TackGrip molded rubber grip
High-quality wrist lanyard
Tactical on/of button
IPX4 waterproof rating
Batteries included (4 AAA)

ANSI/PLATO FL1 STANDARD

MODES|
LUMENS|
RUN TIME|
BEAM DISTANCE
---|---|---|---
High| 550 lm| 1h 45m| 335m
Medium| 185 lm| 9h 30m| 190m
Low| 40 lm| 20h| 85m
Strobe| 465 lm| —| —

Operation Instructions

On/Of: Press and release the button on the tail cap to turn the light on and of.

Cycle Modes: Press the button on the tail cap quickly to cycle through modes (High/Medium/Ultra-Low). If the light remains in a single mode for longer than 3-5 seconds the next press of the button will turn the light off.
Light automatically resets to High mode when turned off.
Hidden Strobe On/Of: Press and hold the button for 3 seconds to activate the hidden strobe. The flashlight will remain in hidden strobe mode until it is deactivated by pushing and holding the button for 3 seconds again.
Once the battery has drained too low to allow the flashlight to run on high mode, the LP600V3 is programmed to turn of. At this point, the fashlight can still run on medium and low modes. Continuously running the flashlight in high mode and turning the light on and of will drain the battery of the light more quickly.

Battery Replacement

The LP600V3 uses 4 AAA batteries.
To change the batteries, turn the tail cap counterclockwise to remove it. Tip the light downward to slide out the battery case which contains the batteries. Remove the batteries from the case and insert new batteries according to the (+/-) symbols found on the case. For best results, we recommend using brand new alkaline batteries that are the same voltage and brand. Re-insert the battery case into a flashlight with the metal knob and arrow on the battery case pointing down. Re-attach the tail cap by pressing down lightly and turning it clockwise until tight.

If you know it will be a while between uses, we suggest removing
the batteries from the flashlight and storing it in a dry, protected
place.

Product Warranty

The LP600V3 has a Limited Lifetime Warranty Against Manufacturer’s
Defects from time of purchase.
For warranty claims please contact us by calling 801-553-8886 or sending an email to info@simpleproducts.com luxpro.com
14725 S Porter Rockwell Blvd Ste C Bluffdale, UT 84065 866.553.8886