Nile Global Inc NSE1000 Wireless Access Point Instructions

Wireless AP
NSE1000

Product Specification

2414-2462MHz: 11b,11g (20MHz) / 11n,llac (20,40MHz)
5180-5240MHz: lla (20MHz) / 11n,llac (20,40,80MHz)
5260-5320MHz: lla (20MHz) / 11n,llac (20,40,80MHz)
5500-5720MHz: lla (20MHz) / 11n,llac (20,40,80MHz)
5745-5825MHz: lla (20MHz) / 11n,llac (20,40,80MHz)
BT: 24022480 MHz: LE 1M
Antenna| Metal PIFA Antenna
Wi-Fi: Dual Band Antenna2 BT: Single Band Antenna1
PCB Size| 10072.501.6
PAC Layer| L6
Memory Size| DDR3 SDRAM 512MB
NAND FLASH 256MB
Power Supply/Adaptor| AC power: 100-240V—,50-60Hz,0.5A
Power consumption| 7W
Install mode| Direct Plug-in Type
Operation temperature| 0 — 45 C
Operation humidity| 5 — 95% Noncondensing
Altitude| 10,000ft (3,048m)

Regulatory Compliance Information:

Safety Notice

• NSE1000 is indoor use Wireless AP.

FCC Requirement for Operation in the United States of

America:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Guideline for Human Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 21 cm between the radiator & your body. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. FCC Caution
• Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
• This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
• For operation within 5.15 ~ 5.25GHz / 5.47 ~5.725GHz frequency range, it is restricted to indoor environment.

Industry Canada statement
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Caution :
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the equipment still complies with the e.i.r.p. limits as appropriate;
(iii) where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated.

Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 24cm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>