AJAX LEAPRO-NA Leak Detector User Guide
- June 6, 2024
- ajax
Table of Contents
Model name:
Ajax LeaksProtect (9NA)
Quick Start Guide
Before using the device, we strongly recommend reviewing the User Manual on
the website.
ajax.systems/support/devices/leaksprotect
Product name: Wireless flood detector
LeaksProtects is a wireless always-active detector to recognize flooding
and notify when the water dries out.
| Frequency range | 905-926.5 MHz FHSS (complies with part 15 of the FCC rules) |
|---|---|
| Maximum RF output power | 12.45 mW |
| Radio signal range | 4,200 ft (line-of-sight) |
| Ingress protection | IP65 |
| Power supply | 2 x AAA batteries |
| Operation from battery | Up to 5 years |
| Operating temperature range | From 32° to 122°F |
| Operating humidity | Up to 100% |
| Dimensions | 2.2 x 2.2 x 0.55 “ |
| Weight | 1.41 oz |
Complete Set:
- LeaksProtect;
- Battery AAA — 2 pcs (pre-installed);
- Quick Start Guide
FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
To maintain compliance with FCC’s RF exposure guidelines, this equipment
should be installed and operated with a minimum distance of 20 cm between the
radiator your body: Use only the supplied antenna.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
ISED Regulatory Compliance
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
To maintain compliance with ISED’s RF Exposure guidelines, this equipment
should be installed and operated with a minimum distance of 20 cm between the
radiator your body: Use only the supplied antenna.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Warranty: The warranty for Ajax devices is valid for two years after the
purchase date and does not apply to the supplied battery. If the device does
not work correctly, you should first contact the support service–in half of
the cases, technical issues can be solved remotely!
The full text of the warranty is available on the website:
ajax.systems/warranty
User Agreement: ajax.systems/end-user-agreement
Technical support: [email protected]
Manufacturer: “AS Manufacturing” LLC.
Address: 5 Sklyarenka Str., Kyiv, 04073,
Ukraine. www.ajax.systems