Shenzhen Hengyunxin Technology M6 Lightning Receiver User Manual
- June 6, 2024
- Shenzhen Hengyunxin Technology
Table of Contents
Shenzhen Hengyunxin Technology M6 Lightning Receiver
Packaging List
- Microphone Transmitter
- l Receiver *1
- USB Type-C Charging Cable 7 Extra Clip7
- Extra Microphone Windscreen
- 2 Storage Bag •7
- User Manual *1
Product Overview
- Microphone Windscreen
- Microphone Indicator
- Microphone Charging Port
- Microphone Clip
- Power Button
- Microphone Reset Pin Hole [Pin is required]
- Port to Connect iPhone/iPad
- Receiver Indicator
- Receiver Reset Pin Hole
- Port of Receiver
Pairing
Step 1:
Receiver: Plug in the iPhone/iPad [The RED light should be on.)
Step 2:
Microphone Transmitter: Press the power button [The GREEN light should be on.)
All set and have fun!
Power off/Disconnect
Microphone Transmitter
Long press the power button for around 5 seconds to turn off If there is no
connectivity, it will shut down after 3 minutes.
Receiver
Plug off the device (light off)
Note: Press the power button of microphone transmitter once to pause(The BLUE light should be on.) The product does not support to make phone calls.
Charging
Microphone Transmitter
- Charging – Blue LED Light on
- Fully Charged – LED Light off
Note: While recording, your iPhone/iPad could still be charged via the Lightning port.
Reset
Kindly take the following steps if the microphone transmitter fails to pair with the receiver.
Step 1:
Plug the receiver in the iPhone/iPad and use the pin to poke the reset pin
hole of receiver twice. (The RED light should be blinking.)
Step 2:
Turn on the microphone transmitter and use the pin to poke the microphone
reset pin hole twice. (The GREEN light should be blinking.) After the second
step, the transmitter and receiver are paired again. The LED light on both
devices will stop blinking.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>