FIAMMA 98655-881 Awning Adapter Kit Instruction Manual
- June 6, 2024
- FIAMMA
Table of Contents
FIAMMA 98655-881 Awning Adapter Kit Instruction Manual
Package contents
Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualified personnel and in compliance with
current local regulations.
ATTENTION: INSTALLATION ON FIXING KIT
The awnings are to be fixed on the brackets so that the words “SUPPORT” on the
awning are in correspondence of the brackets: this condition is necessary and
indispensable for the two brackets situated at the extremities (which are
located on the fixing point of the arms on the case-box). It is important, but
not indispensable, for the central bracket/s as it/they provide/s only a
mounting support.
The brackets must always be well-aligned to each other to avoid later
problems; in case they are not, they must be properly shimmed using the
spacers to ensure the alignment.
The installation of the awning can occur only when the brackets are perfectly
aligned to the roof of the vehicle.
Important: use of SIKA 252 adhesive is essential for fixing the bracket
(brackets).
Attention Security.
Remove this label only after fixing the awning on the adapter.
ATTENTION Periodically check the brackets to make sure they are firmly attached (especially after the first kilometers) make sure the bolts are not loose and that holding brackets have not shifted.
When using the awning please follow the instructions of the product.
Read the following instructions and warnings carefully; failure to observe
these installation and usage instructions as well as the laws for driving in
the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility.
Before installation, ensure compatibility with the vehicle on which the
product must be installed. Checking that the wall/roof/rear door is
sufficiently solid and suitable for guaranteeing the resistance of the
anchoring points is always mandatory. If not, strength and compliance with the
maximum load indicated in the instructions are not guaranteed and it will be
necessary to reinforce it these points.
Dimension
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>