MaestriHouse MMF-BX07 Handheld Milk Frother User Manual
- June 17, 2024
- MaestriHouse
Table of Contents
MaestriHouse MMF-BX07 Handheld Milk Frother
Thank You
Thank you for choosing the Maestri House Hand held Milk Frother. Please read
the manual carefully before using. If you need assistance during use, please
contact us by email at
support@maestrihouse.com.
This manual contains important safety precautions. Please read and follow the
instructions carefully. This product is intended for use in household kitchens
only and is designed for blending liquid food.
Product Features
Ways to Install and Remove the Whisk Rod
Assembling the Whisking Rod:
A **** Hold the milk frother upside down with one hand firmly gripping the body. Insert the whisking rod into the main unit and press the plastic part of the mixing rod firmly with your finger to secure it in place, as shown in Figure A.
B After the whisking rod is installed correctly, the plastic part of the
whisking rod should be flush with the milk frother, as shown in Figure B.
Remove the Whisking Rod:
C Hold the milk frother upside down with one hand firmly gripping the
body. With the other hand, hold the whisking head and push out the whisking
rod vertically and at a constant speed, as shown in Figure C.
Charging Method
For an optimal user experience, please fully charge the milk frother before using it for the first time .
- A :When the power is low, the indicator light flash red until the device is turned off.
- Open the silicon cap and connect Type-C charging cable to power to charge, the white light will slowly flash while charging. (Recommended: use a SV-lA charger).
- The charging time is approximately 4 hours, and the indicator light turns off when fully charged.
B After charging, the silicone plug must be properly assembled and pressed firmly in place, ensuring it is flat and not warped.
Reminder: If you use the frother during the charging process, the indicator light will stay white light and will turn back to the charging state light when stop using.
Usage Method
-
Our frother is very powerful. It is recommended to use a cylindrical shape container with diameter around 90-l00mm and height not less than 110mm. Milk volume should not exceed 1/3 of the container, otherwise the milk might spill out of the container.
-
Pour the desired milk into the container and insert the whisking head of the hand held milk frother into the milk. It’s recommended that the whisking head should be at least 10mm away from the container wall and 5mm away from the bottom of the container .
-
Press the power switch to start the milk frother and enter the whisking mode. Once the milk foam is formed, you can move the milk frother slowly in horizontal and vertical motions. But please ensure that the whisking head is always immersed in the milk. This will increase the whisking area and make rich foam .
-
When the milk is fully foamed, press the power switch again to stop the milk frother.
-
Carefully remove the hand held milk frother from the container.
Reminder: When inserting or removing the whisking rod from liquid, please ensure that the milk frother is turned off to prevent liquid from splashing out.
Cleaning Methods
- Clean the whisking rod and whisking head with water or mild soapy water. You can rinse this part under the faucet.
- If there are stains on the whisking head, you can soak it in a container filled with water or soapy water, then turn on the power switch to clean the milk frother before removing it.
- Use a clean and soft cloth to wipe any stains on the surface of the body. Do not use any chemical or corrosive cleaning agents that could damage the surface.
- Place the cleaned milk frother on a metal storage stand to dry.
Product Parameters
| Product Name | Hand held Milk Frother |
|---|---|
| Product Model | MMF-BX07 |
| Input Voltage | 5V-1A |
| Battery Capacity | 2000mAh |
| Product Size | <p32*290mm(Body) |
| Net weight | 160g(Body) |
Troubleshooting
| Serial No | Fault | Possible Causes | Solution |
|---|---|---|---|
| 1 | The whisking head rotates eccentrically and vibrates greatly | The whisking | |
| rod is not inserted to the end | Slowly and forcefully insert the plastic part |
of the whisking rod into the body, with a gap of,; 0.5mm between the plastic
part of the whisking rod and the body.
Serious deformation of whisking rod| Check visually whether the whisking rod
is bent and deformed due to external force, and if so, manually correct it to
the straight line state under visual condition.
2| Unable to start or turn off halfway| No electricity (red light flashing or
no flashing)| Open the tail plug for charging.
Machine locked| When resistance appears on whisking,White and red lights
flicker alternately. Please turn off the machine immediately to clean the
whisking head.
The load is heavy, and the control board protection causes a power outage|
Move the foam ring of the hand held milk frother out of the load area and
press the power switch again to turn on the machine.
3| Long time for foaming milk| The whisking head has serious eccentric
rotation, large vibration and low| Refer to the processing method of No. l
Unable to foam milk| Confirm whether it is pure milk, preferably whole milk.
Move the whisking head to
immerse it in the milk as much as possible, but do not contact with the
appliance.
Important Notes
- Children are prohibited from operating or playing with this product.
- Do not clean any components of the product in dishwasher.
- Before use or after cleaning, wipe and clean any water spots or stains with a dry, soft cloth.
- After frothing milk, do not turn the handheld frother upside down to prevent residual milk from flowing into the motor and causing it to become stuck or damaged.
- When cleaning the product, do not stand it upside down and directly flush water on it.
- If the product will not be used for an extended period, please charge it every other month.
- If the product malfunctions, please refer to the instructions for frequently asked questions and solutions. Do not attempt to disassemble or repair it yourself.
Packing List
- Hand held Milk Frother * 1
- Whisking Rod * 2
- Metal Storage Stand* 1
- TYPE-C Charging Cable* 1
- Manual* 1
Important Notes
Please dispose of the packaging according to local waste regulations. After scrapping, this product cannot be directly treated as household waste and must be sent to a dedicated recycling station. Thank you for your contribution to the environmental protection industry.
Maestri House provides a 1-yearwarranty on all products. This warranty is valid and enforceable if you have purchased a new product from us or from one of our authorized retailers or resellers in a jurisdiction where we sell our products. If you have any further questions, please feel free to contact us at
About Us
Maestri House is a brand that provides attractive, user-friendly, and fun coffee equipment and services for users who love making their own coffee. To learn more about our products and services, please visit our official website:
Customer Support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>