COSTWAY FP10057US Freestanding Electric Fireplace Stove User Manual
- June 6, 2024
- COSTWAY
Table of Contents
COSTWAY FP10057US Freestanding Electric Fireplace Stove
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Please give us a chance to make it right and do better
Contact our friendly customer service department for help first. Replacements
for missing or damaged parts will be shipped ASAP!
Contact Us!
Do NOT return this item. Contact our friendly customer service department for help first.
E-mail
US:
[email protected]
Before You Start
- Please read all instructions carefully.
- Retain instructions for future reference.
- Separate and count all parts and hardware.
- Read through each step carefully and follow the proper order.
- We recommend that, where possible, all items are assembled near to the area in which they will be placed in use, to avoid moving the product unnecessarily once assembled.
- Always place the product on a flat, steady and stable surface.
- Keep all small parts and packaging materials for this product away from babies and children as they potentially pose a serious choking hazard
When using electrical appliances, basic safety precautions should always be followed including the following:
READ ALL INSTRUCTIONS BEFORE USE AND SAVE THESE INSTRUCTIONS
-
Read all instructions before using this heater.
-
Do not use this heater outdoors.
-
This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate the heater where it may fall into a bathtub or other water container.
-
Do not run the power cord under carpeting. Do not cover the power cord with throw rugs, runners, or the like. Arrange the power
cord away from traffic areas and where it will not be tripped over. -
To disconnect the heater, turn controls to off, then remove the plug from the outlet.
-
Connect to properly grounded outlet only. Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or reloadable power tap (outlet/power strip).
-
To prevent a possible fire, do not block operate the firebox on soft surfaces, like a bed, where openings may become blocked.
-
There is a thermostat limiter inside the heater. When the inner temperature overheat or abnormal heating occurs, the thermostat protective device cuts off the power supply to avoid fireplace from damaged or risk of fire.
-
Use the heater only as described in the manual. Any other use not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons. -
WARNING : Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use.inadequate maintenance, unapproved modification, or neglect of this product.
WARNING:
- There is no user serviceable parts inside fireplace/heater. If the unit appears to malfunction, turn the unit off and unplug from the wall immediately and contact Customer Service.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible material, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3ft (0.9m) from the front of the heater and keep them away from the side or rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Always unplug the heater when not in use.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped, or damaged in any manner. Return the heater to an authorized service facility for examination, electrical or mechanical adjustment, or repair.
- Do not insert or allow foreign objects to enter any ventiliation or exhaust openings as this may cause an electric shock or fire, or damage to the heater.
- A heater has hot and arching or sparking parts inside. Do not use in areas where gasoline, paint, or flammable liquids are used or stored.
CAUTION:
While the heater is in use, the top center of the fireplace can get hot to the
touch, and may cause serious injury or burns. Always supervise small children
around the fireplace/heater. Do not place any cloth or decorations over the
heater outlet or fireplace, or otherwise obstruct the heater outlet of the
fireplace, as this may cause a fire and serious injury.
Specifications
| Model Number | SFS07-17B |
|---|---|
| Dimensions (W x D x H) | 17″x10″x20″ |
| Net Weight | 12.92 lb |
| Gross Weight | 16.12 lb |
| Power Rating | 1400W |
| Voltage | 120V |
| Frequency | 60Hz |
Package Contents
Installation Guide
Assemble Instruction
-
Take out the unit from the box and layout all the spare parts for easy assembly. Make sure all small items
are not left in the packaging materials. -
Lay the unit upside down.
-
Attach the leg to the unit by aligning the tabs on the leg to the slot on the unit.
-
Secure the leg on the unit by tighten 3 screws into the pre-drilled hole.
-
Repeat the above steps for the remaining legs.
Placing the Unit
- Place the unit on smooth level surface.
- Keep combustible objects at least 3ft away from the unit.
- Place the unit to a location that is accessible to grounded power socket
NOTE:
- This unit is intended for indoor use only.
- Do not push, pull, or drag the unit to prevent damage to the legs or the unit.
Installation Guide
Polarized Plug
This product is equipped with a polarized plug (one blade is wider than
another). This plug will only fit into the outlet in one way to reduce the
risk of electric shock. This unit comes standard with a 6ft (1.8m) long, three
wired cord. Always plug the unit into a wall outlet. An
extension or relocate tab should never be used.
CAUTION! WARNING:
DO NOT modify the plug provided with the product if it does not fit the
outlet. Have a proper outlet installed by a qualified electrician
User Instruction
Before use
Check that the air intake and exhaust is not covered or obstructed in anyway.
Plug the unit to a grounded power socket.
Power ON / OFF
Flip the power switch to “ON” position to power on the unit.
Flip the power switch to “OFF” position to power off the unit.
CAUTION! WARNING: DO NOT unplug the unit when it is still “ON”
Heater
Toggle the Temperature switch to turn on the heater. Turn the temperature knob
to select the desired tern peratu re.
Flame Effect
The flame effect will be visible through the front window after turning the
power switch to “ON” position.
Temperature Limiting Feature
This unit will automatically shut off if the heater reaches an unsafe
temperature. To reset, Toggle the power switch to “off” position, unplug the
socket and wait for at least 5 minutes before plugging the unit to a grounded
power outlet and turning on the unit.
User Instruction
Care and Maintenance
Cleaning the unit:
Always turn off the heater and unplug the unit from power outlet before
cleaning. Use a vacuum cleaner or duster to remove dust and dirt from the
heater and vent areas. Use a damp soft cloth to clean the surface and buff
with a dry cloth. Do not use abrasive cleansers, liquid sprays or any cleaner
that could scratch the surface
Welcome to visit our website and purchase our quality products!
With your inspiring rating, COSTWAY will be more consistent to offer you
EASY SHOPPING EXPERIENCE, GOOD PRODUCTS and EFFICIENT SERVICE!
US office: Fontana, California
UK office: Ipswich
- Reward Points
- Exclusive Customer Service
- Personalized Recommendaons
- Permanent Shopping Cart
- Order History
We would like to extend our heartfelt thanks to all of our customers for taking to me to assemble this product and giving us valuable feedbacks