Cub Elecparts TPM201 2.4 GHz Ball Sensor User Guide
- June 6, 2024
- Cub Elecparts
Table of Contents
Cub Elecparts TPM201 2.4 GHz Ball Sensor
Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
andon, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
Operations in the 5.15-5.25GHz band are restricted to indoor usage only. This
device meets all the other requirements specified in Part 15E, Section 15.407
of the FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or
transmitter.
Caution
- This sensor can be used in truck and bus tubeless tires only (rim diameter 22.5″).
- The vehicle speed must not exceed 120 km/h (75 mph).
Installation
For 2.4 GHz type
- Dismount the tire from the rim. If applicable, take out any existing TPMS sensors.
- Use the Cub Retrofit truck tool to program the correct wheel position ID to the sensor, then throw it into the corresponding tire.
- Write the wheel position ID on the label (contained in the 20-pcs package box) and paste it on the outside of the rim, near the valve, as an indicator of the presence of a sensor in the wheel and of the wheel position ID.
Warranty
The driver must obey the speed limit and allowable load according to local
regulations; if not, the TPMS sensor may malfunction and the product warranty
will not be valid.
CUB warrants that the TPMS sensor shall be free from defects in workmanship
and material during warranty period. CUB does not assume any liability in case
of faulty, incorrect installation of the product, or by using other products
causing TPMS sensor malfunction on the part of customer or user.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>