HardHead 010927 Wall-Mounted Hose Reel Instruction Manual
- June 6, 2024
- HardHead
Table of Contents
HardHead 010927 Wall-Mounted Hose Reel Instruction Manual
SAFETY INSTRUCTION
Read these instructions carefully before use, and save them for future reference.
SYMBOLS
TECHNICAL DATA
- Hose diameter: 1/2″
- Hose length: 20 m
- Max working pressure: 8 bar
DESCRIPTION
- Water hose
- Wall bracket
- Guide/lock pin
- Carry handle
FIG. 1
INSTALLATION
-
Use the wall bracket as a template and mark out the position of the holes.
-
Screw the wall bracket to the wall with suitable screws (sold separately) for the actual wall material.
FIG. 2
-
Put the product on the bracket and insert the lock pin.
-
Connect the water hose to the water supply.
FIG. 3
Note: Check before drilling that there are no concealed cables or pipes.
USE
- The product has a brake, which locks the hose when the required length has been pulled out. Activate the brake function by pulling out the hose to the required length from the reel and then slowly releasing it.
- To rewind the hose, pull it out about 20 cm to release the brake and then allow it to be pulled in. Always hold the hose while it is winding in, otherwise there is a risk of material damage.
Note:
- The hose must not be under pressure when it is reeled in. Open the nozzle, turn off the water supply at the tap, and allow all the water to run out before the hose is reeled in.
- Protect the product from freezing. Empty the hose and put the product away before frosty weather.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>