New Bright Industrial 3705HNRR2 Toy Transmitter Instruction Manual
- June 6, 2024
- New Bright Industrial
Table of Contents
New Bright Industrial 3705HNRR2 Toy Transmitter Instruction Manual
App
App Download
Additional features and functions are available and require the user to download and install the ‘App Driver’ app onto a smart device to access. No charge to download. Data rates may apply.
Apple User Search “New Bright App Driver” in the App Store; Install.
Android™ Users: Search “New Bright App Driver” in Android Market or Google Play; Install.
App Set Up
- Install app to device.
- Make certain the vehicle is fully charged (See charging instructions in ‘Recharging the Vehicle’).
- Move ON/OFF switch to the ‘ON’ position (See ‘Vehicle Features’ Of Switch location). Vehicle lights will turn on.
- Launch the App Driver app on your smart device.
- When launching, the app will ask to enable a connection with your device. Select yes to continue to use the app. This allows the app and your device to communicate with the vehicle. (If a proper connection has not been made, you will be prompted to repeat steps 2-4).
- The vehicle and app are now communicating.
- After a connection is established, you will be notified that the control range when using the app is limited. Use the included joystick controller when longer range is needed.
The App features 4 ways to control your vehicle:
- Select ‘Drive Mode’ and choose ‘Touch’ to control your vehicle using the touch screen or select ‘Tilt'”‘ to control your vehicle using the gyroscope sensor in your device. Music, sound and light controls are also available. See instructions in ‘Using the App’.
- Selecting ‘ Draw Mode’ allows you to draw a path and have the vehicle travel along that path. Music, sound and light controls are also available. See instructions in ‘Using the App’.
- Selecting ‘Code Mode’ allows you to program each segment of the vehicle’s path adding sounds, music, and controlling the lights along the way. See instructions in ‘Using the App’.
Tilt Mode Setup:
- After selecting Tilt Mode you will be prompted to set the desired Neutral or Stop position. When your device is held at this position, the car will not move. Placing the device on a flat surface is NOT recommended for this mode. Exit Tilt Mode and start again to recalibrate.
- Remember to exit Titin Mode or close the app when finished or the vehicle may continue to be controlled by the movement of your device.
USING the APP
Home Screen
Below is the App Home Screen. Start by Selecting the Vehicle you have. When the image of your vehicle is displayed you can then select a mode from the 3 mode options on the left.
Driver Mode
Draw Mode
Draw Path Mode allows you to use your finger to draw any path on the screen and the will drive that path. Speed, Lights, Music, Save and Load options are also available. Ref1 ‘More Info’ section for details on these options.
Light Controls
Code Mode
Code Path Mode allows you to select a sequence of directions that the vehicle will follow. Mode. Speed, Lights, Music, Save and Load options are available. Refer to the ‘More Info’ section for details on these options.
Open the Ought Control Menu and drag the desired option Into the Light Input Field to adjust the lights.
To move an Item to a different location, tap and hold for 2 seconds, then drag to desired location. To remove an Item, tap and hold, then drag It off oft he canvas.
TRANSMITTER
Battery Installation
Note: When replacing Transmitter batteries: Do not mix old and new batteries. Do not mix alkaline, standard or rechargeable batteries. Use alkaline batteries only.
Features and Functions
This transmitter is equipped with 2.4GHz technology which allows up to 6 vehicles to be same time.
Once vehicle and transmitter batteries have been correctly installed and vehicle o r Switch is in the ON position, the transmitter will automat icily sync with the.
Smart Phone Holder
Locate the Smart Phone Holder at the back of the transmitter. Flip forward into the upright Next, gently pull up on the clamp while sliding phone in. Release clamp when phone is in pie
