New Bright Industrial GF31TRR2 Toy Transmitter User Manual
- June 6, 2024
- New Bright Industrial
Table of Contents
New Bright Industrial GF31TRR2 Toy Transmitter User Manual
Trouble Shooting
Problem – Vehicle does not move or moves slowly.
- Has the rechargeable Internal Battery been fully charged?
- Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
- Are the (+) and (—) markings on the alkaline batteries in the same position as the (+) and (—) markings in the Transmitter Battery Compartment?
- Make certain that the vehicle ON/OFF switch is in the “ON” position.
Problem – Vehicle moves by itself or exhibits reduced range from the transmitter.
- Make certain there is no outside radio interference in your area. The best way to test this is to take the vehicle as far away from radio towers, electrical lines or tall buildings as possible to ensure no further radio interference will occur.
Problem – App is not controlling vehicle.
- Make certain the proper connection or permission has been enabled on your device.
Contact New Bright Industries Customer Service Toll Free at:
1-877-N8I-TOYS (1-877-624-8697)
Monday through Friday, 8:00 AM to 5:00 PM Eastern Time
U.S. Toy Sales and Marketing Co. Inc. 30260 Oak Creek Drive — 2nd Floor Wixom MI 48393 1 -877-624-8697 http://www.newbright.com/
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Vehicle Features
Vehicle has working lights. When vehicle is powered ON, lights will glow Red.
When vehicle is in motion the lights will glow Blue. When vehicle stops,
lights will glow Red again.
Recharging the Vehicle
This vehicle is equipped with an internal Lithium-Ion battery that is recharged via USB.
ON/OFF Switch must he in the OFF position prior to charging.
- Locate the Charging Cord Compartment Cover on the underside of vehicle.
- Open Storage Compartment Cover.
- Remove USB cable from the Storage Compartment. (Use care when extending cord as it is attached to inside internal battery). Cord can be plugged into any computer or USB outlet brick (not included).
- Insert the USB connector into a computer or other USB power source.
- While charging, the Charging Status Light under the vehicle will be on. Once fully charged the light will turn off. Charging is completed in approximately 1.5-2 hours (when charging from a computer).
- After charging is complete, store the USB cord in the Charging Cord Compartment. Replace the Compartment cover.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>