ohsnap WCSC1BLK002 DC5V Packaging Bottom Sticker Snapcharge Instructions
- June 6, 2024
- ohsnap
Table of Contents
77mm Dia
. Hide ‘LAYOUT’ layer for printing
oh snap!
INPUT: DC5V/9V/12V 2A OUTPUT: DC5V/9V/12V 15W MAX
2021 Ohsnap Inc. All rights reserved.
Designed by Oh snap in the USA Made in China
CONTENTS: Emotional Support, Social Status, Existential Relief (and
Snapcharge) 80mm Diameter
FCC STATEMENT
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device complies with Part 15 of the FCC Rules,
the operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment. Radiation exposure statement this equipment complies
with FCC radiation exposure limits set forth for an uncontrolled environment
this equipment should be installed and operated and operated with minimum
distance 20cm between the radiator and your body.
oh snap!
FCC STATEMENT
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.