INOGENI B09JPDQ9SB Toggle USB 3.0 Switcher User Guide
- October 27, 2023
- INOGENI
Table of Contents
INOGENI B09JPDQ9SB Toggle USB 3.0 Switcher
VERSION HISTORY
Version | Date | Description |
---|---|---|
1.0 | April 9, 2021 | First release |
1.1 | May 20, 2021 | Update RS232 commands section. Change « HOSTx » for « PCx |
».
TYPICAL APPLICATION
Here is a typical connection diagram used for the TOGGLE device in a videoconferencing setup.
DEVICE INTERFACES
Here are the devices interfaces.
- RS232 and GPIN interfaces
- 3 x USB-A ports for devices
- PC #1 USB-B port
- PC #2 USB-B port
- Push-button
- +12V power input
- PC #1 led indicator
- PC #2 led indicator
- Power indicator
LEDS BEHAVIOR
Here are the leds behavior
IMPORTANT : If all leds are blinking in sync, this means the unit is in the upgrade process. This happens only while you upgrade the unit
OPERATING MODES
There are two modes supported by the device. They will be explained here.
Automatic
This is the default mode. This mode will switch automatically to the last PC1
connected. If the current PC is disconnected, the device will switch back to
the other PC if it is detected. Push-button action and remote control are also
supported.
Manual
The manual mode will enable you to force a specific PC selection. Push-button
action and remote control are also supported.These modes can be set through
our INOGENI Control App or through the RS232 interface. The mode will be saved
onboard the device.
SPECIFICATIONS
Here is the complete specification.
SERIAL COMMUNICATION PROTOCOL
Here is the complete list of commands provided through the serial connection: Pinout is indicated on the enclosure.
Baud rate : 9600
All commands will append to the return values return 2 possible answers: “ACK” or “NACK” with “/n/r” chars.
SETTINGS
Some settings can be saved with the “SAVE” command. These settings are:
- Presence or absence of events on serial ports. Events are used for diagnostic. An event returned by the unit always starts with the string “EVT:” The “SEV” serial command is used to enable/disable the events. This command also automatically saves this setting inside the device.
- Manual or automatic mode for PC selection. The “SM” command is used to switch between manual and automatic modes. This command also automatically saves this setting inside the device.
- If manual mode is selected: the specific PC selected is also saved. The “SH” command is used to select between PC1 and PC2. This command also automatically saves this setting inside the device.
- The “DEF” command restores the default settings of the device. It will take effect immediately. The factory default settings are:
- No events.
- Automatic mode for PCx selection.
INOGENI CONTROL APP
You can use our Control App to monitor firmware information, upgrade your unit using the latest firmware and configure your unit.
SUPPORT
Engineered by video professionals, for video professionals, it is your most compatible USB 3.0 device. INOGENI expertise at your fingertips:
- Expert Technical Support team at support@inogeni.com for immediate help or if you have any technical question about our products.
- Extensive Knowledge Base to learn from other customers experiences. © Copyright 2021 by INOGENI INC. All Rights Reserved.
INOGENI name and logo are trademarks or registered trademark of INOGENI. Use of this product is subject to the terms and conditions of the license and limited warranty in effect at the time of purchase. Product specifications can change without notice. INOGENI, Inc. 979 de Bourgogne avenue, suite 530 Québec G1W 2L4 (QC) Canada
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>