KLEIN TOOLS S1656-20H Chicago Grip User Manual
- June 6, 2024
- KLEIN TOOLS
Table of Contents
Recommended Care and Maintenance of Klein®Grips
WARNINGS:
- For use by properly trained professionals ONLY.
- Grips are to be used for temporary installation, NOT for permanent anchorage.
- When used on or near energized lines – ground, insulate, or isolate grip before pulling.
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- Always match proper grip to application.
- DO NOT exceed rated capacity.
SELECTION:
Three factors are used to select the proper grip application:
- Type of wire or cable.
- The outside diameter of wire or cable.
- Maximum safe load required.
Tools to assist within proper selection:
- See our interactive Grip Selection Guide.
- Contact your local Klein Tools Distributor.
- Call Klein Tools at 1-844-395-3235 or 1-800-KLEIN76.
OSHA INFORMATION:
OSHA requires that all hand tools and equipment be maintained in good working
order and that they be free from damage caused by wear or abuse (OSHA Part
1910, Subpart P, Section 1910.242). In addition, OSHA Part 1926, Subpart V,
Section 1926.955, paragraphs (C) (7) (ii) and (C) (8) specifically state that:
“The manufacturer’s load rating shall not be exceeded for stringing lines,
pulling lines, sock connections, and all load-bearing hardware and
accessories.” “Conductor grips shall not be used on wire rope unless designed
for this application.”
See back for cleaning, lubricating and inspection instructions.
CLEANING:
- Use the Klein Grip Cleaning Wire Brush (Cat. No. 25450) or emery cloth to clean the surfaces of grip jaws.
- Spray cleaner-degreaser on the grip jaws, all joints and all moving parts.
- Use the Klein Grip Cleaning Wire Brush to remove dirt and debris from jaws.
- Wipe grips dry with soft cloth.
Repeat all steps until grip is completely clean.
NOTE : Aluminum strand conductors may have a die-grease coating which can
deposit on grip jaws. New aluminum conductors should be wiped clean before
grip application. Grip jaws should be wiped clean of grease before use.
LUBRICATING:
Lubricate all joints and moving parts. DO NOT LUBRICATE GRIPPING SURFACES OF JAWS.
STORAGE:
Always store grip in a dry, cool place.
INSPECTION:
Carefully inspect jaw condition, proper alignment of jaws and all parts, and
possible distortion caused by exceeding safe-load specifications. Grips should
operate smoothly. Spring-loaded grips should lock open with loop handle in
“Down” position and should close automatically with loop handle “Up.” The
Klein parallel jaw grip may be tested by opening and closing the jaws by hand,
exercising proper caution. All parts and rivets should be checked for
distortion.
NEVER ATTEMPT TO REPAIR OR MODIFY ANY GRIP. Grips that are bent,
misaligned, or otherwise distorted should be discarded and replaced. If there
is ever any question about the safe condition of any grip, please contact
Klein Tools directly at 1-844-395-3235
or 1-800-KLEIN76.
WARNING: Cancer and reproductive harm – See www.P65Warnings.ca.gov for more information.
KLEIN TOOLS, INC
Mansfield, TX USA
© 2021
www.kleintools.com
139168 Rev.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>