VOLT THKIT-00X Landscape Lighting Kits Instruction Manual
- June 6, 2024
- VOLT
Table of Contents
VOLT THKIT-00X Landscape Lighting Kits
IMPORTANT
PLEASE READ!
These are installation instructions for landscape lighting kits and individual products such as spot lights, path lights, bulbs, transformers, and hubs. The products you purchased may be different than those represented in this instruction sheet, but will function the same.
Assemble Parts
Transformer Style 1 Option A
Install the stake in the ground. Then attach the riser to the stake. Last,
attach the transformer to the riser.
Transformer Style 1 Option B
Determine the desired location for mounting the transformer. Drill a hole into
the wall surface and insert the wall anchor. Thread the screw into the wall
anchor leaving enough exposed to hang the transformer on. Place the keyhole of
the transformer onto the screw Transformer Style 2
Determine the desired location for mounting the transformer. Drill a hole into
the wall surface and insert the wall anchor. Thread the screw into the wall
anchor leaving enough exposed to hang the transformer on. Place the keyhole of
the transformer onto the screw head. Hubs
Attach the smaller black ground stakes to the hubs. Attach the smaller black
ground stakes to the hubs. Spotlights 1) Remove the top Top
Pathlights: Insert the bulb and attach the top to the stem.
Develop a Plan
- Place the transformer on the home near an electrical outlet that meets electrical codes and allows the photocell, located on the timer, to sense light levels.
- Position the light fixtures as desired near plants, trees, walkways or structures located within 25 feet of the hubs.
- Position each of the hubs so that they’re centrally located among the fixtures per the plan developed.
Set Up Wiring
A. Insert main supply wire into the wire exits on the bottom of the
transformer.
Then connect one end of the main supply wire to one lever terminal on the
“COM” tap by simply lifting the lever up, inserting the wire and flipping the
lever down. Then, connect the other end of the supply wire to the 12V lever
terminal for shorter runs or 15V terminal for longer runs. . NOTE: Transformer
Style 1 utilizes only a 15V terminal.
B. Run the supply wire to the centrally located hubs and insert the wire through the rubber grommets on the bottom of the hub. Then, flip one of the terminal levers open, insert one end of the stripped supply wire, and flip the lever closed to make your connection. Last, flip the lever open that is directly opposite from the first connection, on the other side of the terminal block, insert the other end of the supply wire and flip the lever closed to make the connection. C.Run the fixture wire to the hub and insert the wire through the rubber grommets on the bottom of the hub. Then, flip one of the terminal levers open, insert one end of the stripped fixture wire, and flip the lever closed to make your connection. Last, flip the lever open that is directly opposite from the first fixture wire connection, on the other side of the terminal block, and insert the other end of the fixture wire and flip the lever closed to make the connection.
Test Lights
A.Plug in the transformer and ensure the green pilot light turns on; this
guarantees thetransformer is receiving power from the wall outlet. Manually
switch the timer to the“ON” position and verify the fixtures light up.
B.Once you have verified the fixtures light up, turn the timer to the desired
settings.2Hrs4HrsSETRESETSENSOR8HrsOFFPOWERLOADDUSK-DAWNON4Hrs 6Hrs
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>