BaByliss PRO FXFS1 Series Cordless Metal Single Foil Shaver Instruction Manual

: June 6, 2024
: BaByliss PRO

Table of Contents

FXFS1 Series Cordless Metal Single Foil Shaver
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FXFS1 Series Cordless Metal Single Foil Shaver

FXFS1 Series IB-15501C.indd 1-2

Operating Instructions
CORDLESS METAL SINGLE FOIL SHAVER

Models FXFS1 Series
For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
2021/3/25 5:43 PM

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, especially when children are present, basic safety precautions should always be taken, including the following:

READ ALL INSTRUCTIONS BEFORE USING KEEP AWAY FROM WATER DANGER

Any appliance is electrically live, even when the switch is off. To reduce the risk of death or injury by electric shock:

Always turn appliance off immediately after using.
Do not place or store appliance where it could fall or be pulled into a tub
or sink.
Do not use appliance while bathing or in the shower.
Do not place appliance in, or drop into water or other liquids.
If appliance has fallen into water, do not reach for it.
Turn appliance off before cleaning.

WARNING To reduce the risk of burns, electric shock, fire, or
injury to persons:

Never leave appliance on while unattended.
Close supervision is required when this appliance is used by, on, or near children, or persons with limited physical, sensory, or mental capabilities or invalids.
Use appliance only for its intended use as described in this manual. Use only attachments recommended by the manufacturer.
Never operate the appliance if it has been dropped or damaged, or dropped into water. Return the appliance to a BaBylissPRO Service Center for examination and repair.
Keep the appliance away from heated surfaces.
Never drop or insert any object into any opening on the appliance.
FXFS1 Series IB-15501C.indd 3-4
Do not place the appliance on any surface while it is operating.
Do not use this appliance with a damaged or broken foil or cutter, as injury to skin may occur.
Do not use the appliance outdoors or where aerosol (spray) products are being used or where oxygen is being administered.
Do not crush, or heat above 212° F (100° C) or incinerate the appliance, due to risk of fire, explosion or burns.

SAVE THESE INSTRUCTIONS

OPERATING INSTRUCTIONS
IMPORTANT

This shaver has been engineered to give you a clean, close, smooth shave. It requires 2 AA batteries (included). We recommend using longer-lasting alkaline batteries in your shaver. If you are not going to use your shaver for a long period of time or if the batteries are dead, remove or replace the batteries from the unit.

Remove the metal housing by sliding the bottom switch over and pulling the cover off.
Align the 2 AA batteries with the positive and negative positions indicated inside the battery compartment. Being careful not to bend the springs, insert the negative end of each battery first so it will slip easily into place.
Return the metal housing by sliding it over the plastic inner housing until it clicks into place.
To use your shaver, push ON/OFF switch upward to the ON (I) position.
After you finish using your shaver, push down on the ON/OFF switch to turn the shaver OFF (O).
Remove the batteries if the batteries are no longer functional or if the shaver is left unused for an extended period of time.
Clean the battery contacts and also those of the device prior to battery installation.
Remove used batteries promptly.
2021/3/25 5:43 PM
Always purchase the correct size and grade of battery most suitable for the intended use.
Replace all batteries of a set at the same time.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon zinc), or rechargeable (nickel cadmium or nickel metal hydride) batteries.

ON/OFF SWITCH To operate, simply slide switch to the ON (I) position. To stop operation, set to the OFF (0) position.

VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for proper functioning. Failure to regularly clean and oil the blades will void the warranty.

BASIC INSTRUCTIONS FOR USE

Men whose skin is sensitive or easily irritated by shaving, or who suffer
from a skin allergy, should test one section on the leg or arm before using the shaver.
Remove the protective cover and turn on the unit to start shaving. Hold the shaver at a right angle to the area of your face that you want to shave and run the single shaving foil carefully along your skin. Tip: In general, we recommend that you shave against the direction of hair growth, as this is the best way to trim the hair. Pull your skin tight, with your fingers in inaccessible areas, to achieve optimum results.
Switch the shaver off each time after shaving and clean it.
Do not push the shaver on the skin too hard as it could cause irritation, make the shaver warm and prevent a perfect shave.
Please note that it takes 2 to 4 weeks for your skin to adapt to a shaver, so please do not change shaving instruments in this period of time.
If hair is longer than 1/32″ begin by cutting the hair down first with a trimmer, then use shaver for a smooth close finish.
FXFS1 Series IB-15501C.indd 5-6

USER MAINTENANCE INSTRUCTIONS

TAKING CARE OF YOUR SHAVER

Do not remove the shaving foil unit while the shaver is switched on. Always switch the shaver off! Ensure that no water gets into the inside of the shaver to avoid the risk of an electric shock when it is back in operation. Never press on the cutting blades or the shaving foil and do not touch them with hard objects as this can cause irreparable damage to the shaver or parts. Be careful when dealing with the blades, as they are very sharp. Risk of injury! When cleaning, do not apply any detergents or scouring agents and do not use any abrasive or sharp objects. They can cause irreparable damage to the shaver.

NOTE: When cleaning your shaver, make sure the unit is turned off.

CAUTION!

DO NOT run shaver or cutters under water. Use only the small brush (included) to clean.
To clean the external surfaces of the shaver, use a damp cloth. Do not use strong detergents or other chemicals.
To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
The shaver should not be used until it has completely dried.

TO REPLACE FOIL HEAD ASSEMBLY

Remove the foil head assembly by pressing the round release button located
on the side of the shaver. Hold the foil head assembly on both sides and lightly pull away from shaver unit.
Take the replacement foil head assembly (FXRF1) out of package. Align the replacement foil head assembly over the cutters. Carefully move the replacement foil head assembly down towards the shaver unit until it firmly snaps into place. BE CAREFUL NOT TO DAMAGE THE FOIL OR CUTTERS WHILE INSTALLING.
2021/3/25 5:43 PM

TO REPLACE CUTTERS

NOTE: Always replace the cutters and foil head assembly at the same time.

To remove cutters, place your fingers on each side and gently pull up and away from drive shaft.
To replace cutters, remove the new cutters (FXRF1) from the packaging. Align cutter about the drive shaft and lightly push down until it snaps into place.
Replace the foil head assembly, turn shaver on to ensure it is working properly.

Daily Maintenance:

Press the release button on the side of shaver and remove the head assembly (see Fig. 1 & 2).
Use cleaning brush to whisk away any debris on and around cutter (See Fig. 3).
Snap the head assembly closed (see Fig. 4).

Weekly Maintenance:

Repeat steps 1 3 from the Daily Maintenance cleaning steps.
Rinse the head of the shaver under running water (see Fig. 5). NEVER submerge the shaver in water.
Leave head open for drying.
Press the shaver head back into place (see Fig. 4).

BATTERY REMOVAL

Remove the metal housing by sliding the release button over and pulling the
bottom cover off.
Remove batteries by pulling them out and away from battery contacts.
Dispose used batteries.

CORDLESS FOIL SHAVER

LIMITED 2-YEAR WARRANTY (U.S. AND CANADA ONLY)

BabylissPro will repair or replace (at our option) your unit free of charge for 24 months from the date of purchase if the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective product to the service center listed below, together with your purchase receipt and $15.00 for postage and handling. California residents need only provide proof of purchase and should call 1-800-326-6247 for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 24 months from the date of manufacture.

ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 24-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY.

Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you.

IN NO EVENT SHALL BABYLISSPRO BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER.

Some states do not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.

Cleaning Brush

Release Button for Battery Removal

FXFS1 Series IB-15501C.indd 9-10

2021/3/25 5:43 PM

BaBylissPRO Clipper & Trimmer Service Program Replacement parts may be available for your product. Please contact our BaBylissPRO service department by calling
1-800-326-6247. Please provide your product name/model number,
details, date of purchase and part you require. Service Center BabylissPro
Service Department 7475 N. Glen Harbor Blvd.
Glendale, AZ 85307 1-800-326-6247 ©2021 BabylissPro 205 Shelhouse Drive Rantoul, IL 61866
17FA032835 www.babylisspro.com
FXFS1 Series IB-15501C.indd 11-12

IF YOU LIVE OUTSIDE CANADA, PLEASE CONTACT YOUR LOCAL DISTRIBUTOR.

CANADIAN TWO YEAR REPLACEMENT WARRANTY

Dannyco Professional is the exclusive Canadian distributor of this product. We offer the following excellent warranty on your professional electrical appliance. Keep your sales slip. This is your proof of purchase and your guarantee. This guarantee is not valid in case of abuse, misuse, alterations or repairs done by unauthorized persons. Before returning your defective electrical product, please read the warranty conditions listed in this brochure. Should your professional electrical appliance possess a manufacturer’s defect, it may be exchanged by your distributor or Dannyco Professional at no charge within TWO YEARS from date of purchase, if the electrical appliance is accompanied by a proof of purchase. If you are sending your defective appliance which is covered by this guarantee, directly to the Dannyco Professional Service Center, it must be accompanied by the following:

your dated sales slip; 2) a precise description of the defect; 3) your complete return address and daytime phone number; and, 4) a $10 money order for postage and handling.
Please return your defective appliance to: ATTN: Dannyco Professional Service Center CONAIR CONSUMER PRODUCTS ULC 100 Conair Parkway Woodbridge, Ontario L4H 0L2
This warranty applies only to residents of Canada. Products shipped from outside of Canada will not be processed and will not be returned to sender. For questions regarding this product, you may call Dannyco Professional’s Service Centre at: 1-800-363-0707, or email us at customerservice@dannyco.com.
IB-15501C
2021/3/25 5:43 PM