JASCO 17528T Under Cabinet Light Fixture User Manual
- June 6, 2024
- JASCO
Table of Contents
JASCO 17528T Under Cabinet Light Fixture
Operation
Lightbars can be turned on with the remote or by manually switching on and off.
Manual Operation: Slide control switch to on or off position for manual
use.
Remote Operation: Before using the remote for the first time, remove the
clear plastic tab inside the remote control battery compartment. Slide the
switch to the RF (radio frequency) position. Push the remote switch to turn
lights on and off.
NOTE: If lights should become out of sync with the remote control, simply turn all light bars off manually by sliding the control switch to OFF, then back to RF to reset. Turn them back on using remote control. If the light has been turned on manually, the remote will not turn in off.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>