Mitsubishi Electric Nagoya Works WYSAGVDXG-M Wireless LAN and Bluetooth Combo Module User Manual
- June 6, 2024
- Mitsubishi Electric Nagoya Works
Table of Contents
User Manual
Since this module is not sold to general end users directly, there is no user
manual of module.
The following information must be indicated on the host device of this module;
Contains Transmitter Module FCC ID: 2AXQZWYSAGVDXG-M
or
Contains FCC ID: 2AXQZWYSAGVDXG-M
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
*If it is difficult to describe this statement on the host device due to the size, please describe in the user’s manual and also either describe on the device packaging or on a removable label attached to the device.
The following statements must be described on the user manual of the host
device of this module;
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment should be installed and operated keeping the
radiator at least 20cm or more away from person’s body.
The following statements is not for the requirement to describe on the user manual of the host device of this module;
This device complies with below part 15 of the FCC Rules.
Part 15 Subpart C
Part 15 Subpart E
The modular transmitter is only FCC authorized for the specific rule parts
(i.e., FCC transmitter rules) listed on the grant, and the host product
manufacturer is responsible for compliance to any other FCC rules that apply
to the host not covered by the modular transmitter grant of certification. The
final host product still requires Part 15 Subpart B compliance testing with
the modular transmitter installed.