SUPAIR LOUSTIC 2 Harness for Children User Manual
- June 6, 2024
- SUPAIR
Table of Contents
SUPAIR LOUSTIC 2 Harness for Children
INTRODUCTION
Welcome to the world of paragliding according to SUPAIR, a world of shared
passion.
This harness has all the makings of a great one. However, it is a passenger
tandem harness and not a solo harness: your presence as a pilot and your
knowledge of tandem flying are required.
Please also observe the flying and insurance regulations for tandem flights
applicable in your country.
The well-thought-out design and choice of materials were guided by the same
quality and durability objectives.
The LOUSTIC 2 harness was certified EN 1651: 2018 and LTF Nfl II 91/09.
Indicating that it meets European and German safety requirements. After
reading this manual, we suggest you to check your harness in static hang-posts
to adjust it before your first flight.
N.B : Three important icons will help you when reading this manual:`
TECHNICAL SPECIFICATIONS
| Harness size| Unique
---|---|---
| Pilot size (cm)| 80 – 110
| Pilot weight (mini – maxi) (kg)| 8 – 20
| Harness weight (+ carabiners+speedbar)(kg)| 1,15 kg
| Designed for| Paragliding only
A| Back lenght (cm)| 35
B| Backrest tilt adjustment (cm)| 25
C| Seat length (cm)| 21
D| Seat width (cm)| 25
E| Carabiners height (cm)| 31/47
F| Carabiners distance (cm)| 33
| Back protection| No
| Certification| EN 1651 – LTF
| Maximum in flight weight ( certification )| 50 kg
| Tandem (Pilot or Passenger)| Yes
| Aerobatic flying| NO
| Towing| Yes
| Reserve parachute| No
- Back length
- Backrest tilt adjustment
- Seat length
- Seat width
- Carabiners height
- Carabiners distance
SIZE CHOICE
The LOUSTIC 2 is available in one size. It covers an age range from 3 to 6 years, but as children vary greatly in size and build at these ages, it is advisable to try it out under a gantry before purchase.
COMPONENTS LIST
- Harness
- 2x 30 mm Zicral self-locking carabiners
- Polypropylene seat plate
- Teddy bear pocket
HARNESS OVERVIEW
- Backrest angle adjustment
- Shoulder strap adjustment
- Teddy bear pocket fastening
- Main hooking points
ACCESSORIES ASSEMBLY
Carabiners
Compatible carabiners :
30 mm Self-locking sacral carabiners Réf. : MAILCOMOUS30
Seat plate
LS2 polypropylene seat plate
: Réf. : MPPL036
Installing the seatplate :
- Turn over the seat
- Slide the plate under the seat, being careful to put the leg straps behind the plate
COMFORT FOAM
Insert the foam behind the seat and place the side velcros on the foam.
ADJUSTING THE HARNESS
Important: Adjusting the harness prior each takeoff is vital.
The various adjustments
- Adjusting the backrest
- Adjusting the shoulder straps
Adjusting the harness
Without strap tension, first adjust the backrest incline at the desired angle.
- Tightening will bring the backrest at a more vertical angle ( recommended posture for beginners ).
- Loosening the backrest will tilt the back support rearward.
Adjust the shoulder straps length using the trimmers
The pressure on the shoulder straps contributes to general comfort in flight.
It must be precise: not too tight nor too loose. The upper area of the straps
must offer enough support to maintain your torso in a comfortable position.
CONNECTING THE WING TO THE HARNESS
Rigid spreader bars position
Soft spreader bars position
FLIGHT PHASES
Pre-Flight control
- Check that the harness, the carabiners, the spreader bar and in general all your flight equipment are not damaged. As the captain, you are responsible for the safety of the crew
- Check that your personal settings haven’t changed.
- Check that all zippers and buckles are closed.
- Make sure that the self-locking carabiners are locked and connected to the paraglider.
Take-off
After a thorough weather conditions analysis, when the decision to fly has been taken, put your harness on and follow the next steps
- Lock the buckles carefully.
Takeoff maintains a vertical posture and push yourself inside the harness but
only once away from the ridge.
Do not release your hands from the brakes when you are close to terrain.
In-flight
Once up in the air, the LOUSTIC 2 behaviour is stable and instinctive.
Landing
Straighten yourself in your harness and adopt a running posture to dissipate
the horizontal speed. Always be certain to have enough altitude to make a
landing approach corresponding to the weather conditions of the moment and
terrain. During the landing approach, never make hasty maneuvers. Always land
upwind in a standing posture and be ready to run upon touchdown if necessary.
During your final approach, use as much airspeed as possible based on the
weather conditions of the moment, then gradually reduce the glider airspeed by
pushing the toggles all the way down until contact with the ground is made.
Beware not to brake too soon and too rapidly and too deep which could lead to
a stall and a dangerous landing. During high wind speed landings, turnaround
and face the wing as soon as ground contact is made and move toward the wing
while brak-ing symmetrically to deflate it. Do not land in a seated position
as it is dangerous.
TOWING
To takeoff under tow, you must be equipped with a quick-release specially designed for the task. Connect the tow bridle to the wing riser loops with a suitable tow bridle. Installation must follow the tow bridle rules manufacturer’s recommendations. Before towing, you should consult with a competent towing outfit about safety recommendations.
IN CASE OF AN INCIDENT
CARE
Harness cleaning and maintenance
It is a good idea to clean your harness from time to time. We recommend using
a brush and soft solvents only ( soap or mild cleaning agents ). Rinse
thoroughly. Never use aggressive chemicals such as strong solvents which could
be harmful to the harness’s fabric, webbings, stitching, and weaken its
integrity.
The zip fasteners should be lubricated from time to time, using a silicon
spray.
If you regularly use your harness in a dusty environment ( dirt, sand, etc… ),
we advise you to regularly check and maintain your carabiners and buck-les :
clean them with a mild detergent, then blow dry them fully but DO NOT
LUBRICATE!
Prior to using them, conduct thorough carabiners and buckles checkup to ensure
their full functionality.If you use your harness in a marine/sandy/salty
environment, pay particular attention to your gear and follow a rigorous
care/maintenance routine.
Storage and transport
When not in use, your harness should be stored inside your paragliding
backpack, in a dry, cool and clean place, protected from UV exposure. If your
harness is wet, please dry it thoroughly before storing it. For transport,
protect the harness from any mechanical or UV deterioration (use a bag).
Please avoid long transport in wet conditions.
Life span
Once every two (2) years, a thorough harness inspection must be conducted :
- Webbing wear and tear (no excessive wear, no rip beginning, no unwanted folds)
- Buckles and carabiners ( functionality, wear and tear ).
The threads and fabric used for the manufacturing of the LOUSTIC 2 were
specifically selected for their quality and resilience levels. However, in
particular instances such as long-term UV exposure, abrasion, contact with
damaging chemicals, general wear and tear, the harness will need to be
inspected at a professional certified repair facility. Safety comes first!
Super advice to replace the carabiners and spreader bars every 5 years or
after 500 hours of use. The self-locking carabiners are NEVER to be used for
any activities other than paragliding.
Repair
In spite of using the highest quality products to manufacture the LOUSTIC
2, it is possible for your harness to deteriorate through general use. If
showing any sign of wear and tear, it should be sent for inspection and/or
repairs at a professional certified facility.
SUPAIR now offers an extended warranty period reaching beyond the product standard protection plan against manufacturing defects. Please contact us either by telephone or by e-mail at sav@supair.com in order to receive a quotation..
Hardware & Parts
- -elf-locking zicral 30mm carabiners (référence : MAILCOMOUS 30)
- Polypropylene seat plate ( LS2 : MPPL036 )
Materials
-
Fabrics
N/210D 3line Honey Comb
Robic New Lite
Stretch Aquatech -
Webbings
Polyester 25 mm (1250 daN)
Polyamide 15 mm -
Seat Plate
KD2 Polypropylène
Recycling
We have minimized our manufacturing footprint by carefully selecting
environmentally friendly materials; most of our components are recyclable. If
you estimate that your LOUSTIC 2 has reached the end of it life span, you can
separate plastics from metals and recycle them according to your community
rules in effect. As for the fabric itself, contact your local authorities to
find out how to proceed to discard it.
WARRANTY
SUPAIR takes the greatest care in the design and manufacturing of its
products and hence offers a five (5) year limited warranty from the date of
purchase against manufacturing defects or flaws occurring during normal use.
Any damage or degradation resulting from incorrect or abusive use, abnormal
exposure to aggressive factors, including, but not limited to; high
temperature, intense sun exposure, high humidity, etc, will invalidate this
warranty.
DISCLAIMER
Paragliding is an activity requiring specific skills and sound judgment.
Learn how to fly within the environment of a certified paragliding school.
Carry an insurance policy with you in addition to you pilot certification.
Always mind and gauge your personal skills relative to the elements you want
to be flying in. Better be safe than sorry! SUPAIR can not be held responsible
for your paragliding decisions or activities.
This SUPAIR product has been designed exclusively for paragliding. Any
other activity such as skydiving or BASE jumping is absolutely forbidden.
PILOT’S GEAR
It is essential for you to wear suitable head protection ( certified
paragliding helmet ), boots and right clothing for the activity. Moreover,
carrying a reserve parachute connected to your harness in flight is highly
recommended.
SERVICE BOOK
This page will help you keep a record of your LOUSTIC 2 scheduled maintenance.
Thank you for choosing the Loustic 2. We are glad to be able to share our common paragliding passion with you.
SUPAIR has been designing, producing, and selling free-flying equipment since
1984. By choosing a SUPAIR product you benefit from almost thirty years of
expertise, innovation and listening. This is also our philosophy: working
endlessly to develop better products and to maintain a high-quality
production.
We hope you will find this user’s manual comprehensive, explicit and hopefully
enjoyable as well. We advise you to read it carefully.
You will find the latest up to date information about this product on our
website www.supair.com
If you have any further questions, feel free to ask one of our retailers for
answers. And naturally, the entire SUPAIR team is at your disposal at
info@supair.com.
We wish you many safe enjoyable flying hours and happy landings Team SUPAIR
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>