JBL VIBE300TWS True Wireless Earbuds User Guide
- June 6, 2024
- JBL
Table of Contents
JBL VIBE300TWS True Wireless Earbuds
WHAT’S IN THE BOX
how to wear
FIRST TIME USE
power on & CONNECT
DUAL CONNECT
Controls
SterioMode Mono Mode
power off
Manual SETUP
-
Connect to a new Bluetooth device
-
RECONNECT LEFT & RIGHT
-
FACTORY RESET
Charging
led behaviors
TECH SPEC
Model : VIBE300TWS
Driver size : 12 mm/ 0.47” Dynamic Driver
Power supply : 5V 1A
Earbud : 3.85 g per pc (7.7 g combined)/ 0.009 lbs per pc (0.017 lbs
combined)
Charging case : 36 g/ 0.079 lbs
Earbud battery type : Lithium-ion polymer (40 mAh/ 3.85 V)
Charging case battery type : Lithium-ion polymer (500 mAh/ 3.8 V)
Charging time : < 2 hrs from empty
Music playtime with BT on : up to 6 hrs
Frequency response : 20 Hz – 20 kHz
Impedance : 32 ohm
Sensitivity : 105 dB SPL@1 kHz
Maximum SPL : 95 dB
Microphone sensitivity : -38±2 dBV/Pa@1 kHz
Bluetooth version : 5.2
Bluetooth profile version : A2DP V1.3 AVRCP V1.6 HFP V1.7
Bluetooth transmitter frequency range : 2.4 GHz – 2.4835 GHz
Bluetooth transmitter power : <12 dBm
Bluetooth transmitter modulation : GFSK, /4–DQPSK, 8–DPSK
Maximum operation temperature : 45 °C
IC RF Exposure Information and Statement
The SAR limit of Canada (C) is 1.6 W/kg averaged over one gram of tissue. Device types: (IC: 6132A-JBLV300TWS) has also been tested against this SAR limit According to this standard, the highest SAR value reported during product certification for head use is 0.59560.5936 W / kg. The device was tested for typical bodily operations where the product was kept 0 mm from the head. To maintain compliance with IC RF exposure requirements, use accessories that maintain a separation distance of 0mm between the user’s head and the back of the headset. The use of belt clips, holsters and similar accessories shall not contain metal parts in its assembly. Use of accessories that do not meet these requirements may not comply with IC RF exposure requirements and should be avoided.
Head operation
The device was subjected to a typical head manipulation test. In order to
comply with RF exposure requirements, a minimum separation distance of 0 cm
must be maintained between the user’s ear and the product (including the
antenna). Head exposure that do not meet these requirements may not meet RF
exposure requirements and should be avoided. Use only the supplied or approved
antenna.
IC: 6132A-JBLV300TWS
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.
Documents / Resources
| JBL
VIBE300TWS True Wireless
Earbuds
[pdf] User Guide
JBLV300TWS, APIJBLV300TWS, VIBE300TWS True Wireless Earbuds, VIBE300TWS, True
Wireless Earbuds
---|---