JBL TUNE 130NC Noise-Canceling True Wireless In-Ear Headphones User Guide
- June 6, 2024
- JBL
Table of Contents
TUNE 130NC
Wireless In-Ear Headphones
User Guide
WHAT’S IN THE BOX
APP
GET EVEN MORE CONTROL AND PERSONALIZATION OF YOUR LISTENING EXPERIENCE WITH THIS FREE APP.
HOW TO WEAR
FIRST TIME USE
POWER ON & CONNECT
DUAL CONNECT + SYNC
CONTROLS
- Enable advance controls by connecting your JBL TUNE130NC TWS to JBL Headphones App.
** ENABLE YOUR VOICE ASSISTANT THROUGH JBL HEADPHONES APP AND ASSIGN IT TO YOUR PREFERRED EARBUD (L/R).
POWER OFF
MANUAL SETUP
DO MORE WITH THE APP
CHARGING
LED BEHAVIORS
TECH SPEC
Model: TUNE130NCTWS
Driver Size: 10 mm/ 0.394” Dynamic Driver
Power supply: 5V 1A
Earbud: 5.7 g per pc (11.4 g combined)/ 0.012 lbs per pc (0.024 lbs combined)
Charging case: 40.4 g/ 0.087 lbs
Earbud battery type: Lithium-ion polymer (70 mAh / 3.85 V )
Charging case battery type: Lithium-ion polymer (750 mAh / 3.7 V)
Charging time: 2 hrs from empty
Music play time with BT on and ANC off: up to 10 hrs
Music play time with BT on and ANC on: up to 8 hrs
Frequency Response: 20 Hz – 20 kHz
Impedance: 32 ohm
Sensitivity: 103 dB SPL@1 kHz
Maximum SPL: 94 dB
Microphone sensitivity: -10 dBV/Pa@1 kHz
Bluetooth version: 5.2
Bluetooth profile version: A2DP 1.3, AVRCP 1.6, HFP 1.7
Bluetooth transmitter frequency range: 2.4 GHz – 2.4835 GHz
Bluetooth transmitter power: <12 dBm EIRP
Bluetooth transmitter modulation: GFSK, π/4-DQPSK, 8-DPSK
Maximum operation temperature: 45°C
IC RF Exposure Information and Statement
The SAR limit of Canada (C) is 1.6 W/kg averaged over one gram of tissue.
Device types: (IC: 6132A-T130NCTWS) has also been tested against this SAR
limit According to this standard, the highest SAR value reported during
product certification for head use is 0.3643 W / kg.
The device was tested for typical bodily operations where the product was kept
0 mm from the head. To maintain compliance with IC RF exposure requirements,
use accessories that maintain a separation distance of 0mm between the user’s
head and the back of the headset. The use of belt clips, holsters and similar
accessories shall not contain metal parts in its assembly. The use of
accessories that do not meet these requirements may not comply with IC RF
exposure requirements and should be avoided.
Head operation
The device was subjected to a typical head manipulation test. In order to
comply with RF exposure requirements, a minimum separation distance of 0 cm
must be maintained between the user’s ear and the product (including the
antenna). Head exposure that do not meet these requirements may not meet RF
exposure requirements and should be avoided. Use only the supplied or approved
antenna.
WARNING DO NOT ATTEMPT TO OPEN, SERVICE, OR DISASSEMBLE THE BATTERY | DO NOT SHORT CIRCUIT | MAY EXPLODE IF DISPOSED OF IN FIRE | RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE | DISPOSE OR RECYCLE USED BATTERIES ACCORDING TO THE INSTRUCTIONS
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc., and any use of such marks by HARMAN International
Industries, Incorporated is under license. Other trademarks and trade names
are those of their respective owners.
FCC ID: APIT130NCTWS
Google, Android and Google Play are trademarks of Google LLC. Amazon, Alexa, Amazon Music, and all related logos are trademarks of Amazon, Inc. or its affiliates.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>