LIFAair LAH302 Smart Air Purifying Humidifier User Manual
- June 6, 2024
- LIFAair
Table of Contents
LAH302 Smart Air Purifying Humidifier
Please read this user manual carefully before using, it and keep it for
future reference.
Preface
Thank you for choosing LIFAairl You are about to enjoy superior Finnish technology and innovation.
Packing List
Function Description
-
Photosensitive sensor/water pouring reaction/display screen
-
Touch control circle/buttons
Fan speed up press to increase by the level press and hold to increase continuously ‘
Cleaning mode: press and hold to start cleaning mode
Night mode: press and hold to enable/exit night mode
Smart/manual mode: press and hold to switch between smart mode and manual mode
Power on/standby/wet curtain air-drying mode: press and hold: power on – wet curtain air-drying mode -standby (if the water level is too low, the wet curtain air-drying mode does not function)
Energy-saving mode: press and hold to enable/exit energy-saving mode
Humidifying mode: press and hold to enable/exit humidifying mode (target humidity: 60%); target humidity is 50% when the “A” icon is not displayed.
Child lock switch: press and hold to enable/exit child lock mode
Fan speed down press to decrease by the level press and hold to decrease continuously -
Air inlet
-
Power cable
-
Water barrel
Press and hold the buttons simultaneously: check filter lifespan
Press and hold the buttons simultaneously: reset filter lifespan
Press and hold the buttons simultaneously: check device information
Press and hold the buttons simultaneously: enter Wi-Fi network connection
Note: Do not block the intake and exhaust opening.
Use
Add water
The display screen shows the current water level. When it shows ‘Low Water Level Add Water, the humidifier must be refilled to continue operating. Slowly add water. First, pour water onto the display screen, it will auto-switch to the “Water Level” interface. When the water level reaches 100% along with a prompt tone, please cease to add water to avoid spilling. If the water level is too low, the humidifier will not operate; If the water level is too high, there will be a prompt.
UV disinfection light
When the water level is over 90% for the first time, or the water level is over 90% for more than 24 hours, the UV disinfection light will auto-operate for 20 minutes. In subsequent use, the UV disinfection light will also auto- operate for 20 minutes if the water level is below 60% and then refilled to over 90%. The UV light operation does not interfere with the normal operation of the humidifier. The UV disinfection light function can be canceled via the APP in the mobile phone.
Note: Due to product and software upgrades, the operation interfaces shown on this manual may be slightly different from the actual product. If any difference is found, the actual product prevails.
Water barrel cleaning (be sure the main unit is not operating, unplug the power cord, and then proceed to clean the water barrel) A weekly barrel cleaning is recommended. Turn the power off, then lift the main unit by hand and place it into a dedicated empty water barrel.
Note: When removing the main unit for barrel cleaning and cleaning mode, please turn the power off to lift the main unit by hand and place it into a dedicated empty water barrel as shown above. Please also move the humidifier in this way. Slightly tilt the main unit, hold the main unit with one hand, and hold the bottom of the empty barrel with the other hand, then proceed to move.
Cleaning mode
Please follow the steps below to perform a cleaning every two months:
a) confirm that the water level of the water barrel is below 30%;
b) turn the power off;
c) remove the main unit;
d) drop the specified amount of citric acid into the water barrel and let it
fully dissolve;
e) place the main unit back onto the water barrel;
f) turn the power on;
g) press the “A.:’ icon;
The humidifier will auto-run the pump continuously for 30 minutes. After
cleaning is completed, there will be a prompt tone and ‘Cleaning Mode Done
will be shown on the display screen. Then:
a) turn the power off;
b) remove the main unit;
c) clean the water barrel;
d) place the main unit back onto the water barrel;
e) turn the power on;
And then:
a) pour the water from the top to reach around 50%;
b) press the “A.’ button again;
c) turn the power off when hearing a prompt tone in 30 minutes;
d) remove the main unit;
e) pour water thoroughly out of the water barrel;
f) place the main unit back onto the water barrel;
g) turn the power on;
h) add water.
The cleaning has been completed.
Tilting warning
Note: Use caution to avoid tilting the humidified The main unit will turn off when tilted.
Manually control fan speed
Control the fan speed as convenient as this)
Touch the top circle of the main unit and clockwise to increase the fan speed.| Touch the top circle of the main unit and rotate rotate counter- clockwise to reduce the fan speed.
APP connection
http://www.lifa-air.com/en-gb/app
Scan the QR code to download and install the LIFAair APP. After installation is completed, add the device to the APP, and follow instructions to operate.
Wet curtain and HEPA filter replacement
(be sure the main unit is not operating, unplug the power cord, and then
proceed to replace wet curtain and/or filter)
The humidifier has a reminder feature. When the ‘Filter Lifespan” indicated by
the display screen reaches below 5%, the APP will warn you to replace it soon.
Press and hold the buttons simultaneously to check HEPA filter lifespan.
Please carefully separate the main unit and the water barrel, and avoid tilting as there is water in the water barrel.| Cover the ground with a soft towel or a protective pad, flip the main unit upside down and rotate the bottom cover to unlock the position. Make sure the power is cut off.| Lift my hands to take out the wet curtain.
After the replacement is completed, press and hold the ‘V’ “A1 buttons simultaneously to reset the HEPA filter and wet curtain lifespan, so as to re- start the smart monitoring for the HEPA filter and wet curtain lifespan.
Rotate counter-clockwise to take out the wet curtain for replacement.| Take out the HEPA filter for replacement.| After replacing the HEPA filter and wet curtain, please reinstall in reverse order. Flip the main unit carefully back to the upright position. Then turn the power on for use.
Specifications
Product name: Smart Air Purifying Humidifier
Model number: LAH302
Rated humidification capacity: 1000mUh
Hurnichhcabon efficiency: 2.2m1/(h•W)
Rated water barrel capacity-. 6.SL
Sound power level noise: <60dB(A)
Rated input: 220-240V — 50/60Hz
Rated power: 450W/25W (Energy-saving mode)
Particle Clean Air Delivery Rate (CADR particulate matter): 180m3/h
Note: Performance data above are in accordance with GB/T23332-2018 and GB/718801-201S tested by the third-party Laboratories.
Troubleshooting
Humidifier not working?
Please check whether the power cord is correctly connected. Please check
whether the humidifier is at minimum fan speed. Please check whether the
bottom cover is in the lock position.
Running nose?
Please check whether the NEPA filter is installed.
Fan still running when powered off?
Due to water residual on the wet curtain, the humidifier will automatically
perform a wet curtain air-drying to prevent bacteria from growing in a humid
environment.
Customer Service — International If you have any questions, please contact us
at Carmelita-air.com or visit us at vmw.hfaair.com
Please note: All rights to change or modify the product without prior notice
are reserved.
LIFAair Oy Ltd.
Vellamonkatu 30 B 00550 Helsinki Finland
Manufactured by Dongguan LIFAair Technology Limited
Address: No. 2, East Industry Road, Songshan Lake Science &
Technology Industrial Park, Dongguan, 523808, CHINA
wwwlifaair.com Designed in Finland
IB-200-1AH302-00 V1.0
Documents / Resources
|
LIFAair LAH302 Smart Air Purifying
Humidifier
[pdf] User Manual
LF01, 2A2LR-LF01, 2A2LRLF01, LAH302 Smart Air Purifying Humidifier, LAH302,
Smart Air Purifying Humidifier
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>