Shenzhen Shentongdayun Electrical BC42 Charging Station Instruction Manual
- June 6, 2024
- Shenzhen Shentongdayun Electrical
Table of Contents
This port is ONLY designed for AirPods/AirPods Pro.
DO NOT charge the phone here, or it may destroy the plug.
The port is compatible with most USB-Charged devices, like Phones, Earbuds, USB lamps, SmartWatch, and so on.
Conido recommends adapter QC 2.0/3.0 standard or above (Adapter is Not
Included).
The wireless charging board has high-temperature protection , only need to
try again later if there’s a temporary stop to charge.
Charging stand
Model NO.: BC42
1 Highest internal frequency: 205kHz SI
2 Input: 9V/2.5A-9V/3A
3 Output: 10W/5W/5W (Max)
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20cm the radiator your body: Use only the supplied antenna.