ROBOTIS CM-151 Device Instruction Manual
- June 6, 2024
- ROBOTIS
Table of Contents
CM-151 manual
Specifications
-
MCU: 32-bit ARM® Cortex®-M4F @ 64 MHz
-
Voltage Supply
▶ Battery : Without CM-151 controller.
– Range : 3.3 ~ 4.2[V] – Normal voltage : 3.7[V] (Li-ion battery) -
Operating Temperature : -5~70[°C]
-
Bluetooth
: Bluetooth 5.1 compliant single-mode Bluetooth Low Energy -
BUZZER
-
Condeser mic: Detect applause
-
External I/O Device :
A. micro USB (for data communication)
B. remote control receiver connector
C. MOTOR CONNECTOR *2 ea
FCC Information
This device complies with part 15 of the FCC Results. Operation is subject to
the following two conditions : (1) This device may not cause harmful
interface, and (2) This device must accept any interference received.
including interference that may cause undesired operation.
Note This equipment has been tested and found to comply with the limits
for CLASS 8 digital devices, pursuant to Part 15 of FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.1. Reorient or relocate the receiving antenna.
12. Increase the separation between the equipment and receiver.
13. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
1.4. Consult the dealer or experienced radio/TV technician for help
WARNING Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.
IMPORTANT NOTE:
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 centimeters between the radiator and your body. This
transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>